Datasheet

PIC18CXX2
DS39026D-page 240  1999-2013 Microchip Technology Inc.
21.2 DC Characteristics: PIC18CXX2 (Industrial, Extended)
PIC18LCXX2 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA  +85°C for industrial
-40°C T
A  +125°C for extended
Param
No.
Symbol Characteristic Min Max Units Conditions
V
IL Input Low Voltage
I/O ports:
D030 with TTL buffer Vss 0.15VDD VVDD < 4.5V
D030A — 0.8 V 4.5V  V
DD 5.5V
D031 with Schmitt Trigger buffer
RC3 and RC4
Vss
Vss
0.2VDD
0.3VDD
V
V
D032 MCLR
VSS 0.2VDD V
D032A OSC1 (in XT, HS and LP modes)
and T1OSI
V
SS 0.3VDD V
D033 OSC1 (in RC and EC mode)
(1)
VSS 0.2VDD V
V
IH Input High Voltage
I/O ports:
D040 with TTL buffer 0.25VDD +
0.8V
VDD VVDD < 4.5V
D040A 2.0 V
DD V4.5V  VDD 5.5V
D041 with Schmitt Trigger buffer
RC3 and RC4
0.8V
DD
0.7VDD
VDD
VDD
V
V
D042 MCLR
, OSC1 (EC mode) 0.8VDD VDD V
D042A OSC1 (in XT, HS and LP modes)
and T1OSI
0.7V
DD VDD V
D043 OSC1 (RC mode)
(1)
0.9VDD VDD V
IIL Input Leakage Current
(2,3)
D060 I/O ports — 1 AVSS VPIN VDD,
Pin at hi-impedance
D061 MCLR
— 5 AVss VPIN VDD
D063 OSC1 — 5 AVss VPIN VDD
I
PU Weak Pull-up Current
D070 IPURB PORTB weak pull-up current 50 400 AVDD = 5V, VPIN = VSS
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that
the PIC MCU be driven with an external clock while in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.