Datasheet
PIC17C7XX
DS30289C-page 244 1998-2013 Microchip Technology Inc.
20.2 DC Characteristics: PIC17C7XX-16 (Commercial, Industrial, Extended)
PIC17C7XX-33 (Commercial, Industrial, Extended)
PIC17LC7XX-08 (Commercial, Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature
-40°C T
A +125°C for extended
-40°C T
A +85°C for industrial
0°C T
A +70°C for commercial
Operating voltage V
DD range as described in Section 20.1
Param.
No.
Sym Characteristic Min Typ† Max Units Conditions
Input Low Voltage
VIL I/O ports
D030 with TTL buffer (Note 6) Vss
Vss
–
–
0.8
0.2V
DD
V
V
4.5V VDD 5.5V
3.0V V
DD 4.5V
D031 with Schmitt Trigger buffer
RA2, RA3
All others
Vss
Vss
–
–
0.3V
DD
0.2VDD
V
V
I
2
C compliant
D032 MCLR
, OSC1 (in EC and RC
mode)
Vss – 0.2VDD V (Note 1)
D033 OSC1 (in XT, and LF mode) – 0.5V
DD –V
Input High Voltage
VIH I/O ports
D040 with TTL buffer (Note 6) 2.0
1 + 0.2V
DD
–
–
V
DD
VDD
V
V
4.5V VDD 5.5V
3.0V V
DD 4.5V
D041 with Schmitt Trigger buffer
RA2, RA3
All others
0.7V
DD
0.8VDD
–
–
VDD
VDD
V
V
I
2
C compliant
D042 MCLR
0.8VDD –VDD V (Note 1)
D043 OSC1 (XT, and LF mode) – 0.5V
DD –V
D050 VHYS Hysteresis of
Schmitt Trigger Inputs
0.15VDD ––V
† Data in “Typ” column is at 5V, 25C unless otherwise stated.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC17CXXX devices be driven with external clock in RC mode.
2: The leakage current on the MCLR pin is strongly dependent on the applied voltage level. Higher leakage
current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
4: These specifications are for the programming of the on-chip program memory EPROM through the use of the
table write instructions. The complete programming specifications can be found in: PIC17C7XX Programming
Specifications (Literature number DS TBD).
5: The MCLR
/VPP pin may be kept in this range at times other than programming, but is not recommended.
6: For TTL buffers, the better of the two specifications may be used.