Datasheet

PIC17C7XX
DS30289C-page 30  1998-2013 Microchip Technology Inc.
Bank 7
PW3DCL 10h xx0- ---- uu0- ---- uuu- ----
PW3DCH 11h xxxx xxxx uuuu uuuu uuuu uuuu
CA3L 12h xxxx xxxx uuuu uuuu uuuu uuuu
CA3H 13h xxxx xxxx uuuu uuuu uuuu uuuu
CA4L 14h xxxx xxxx uuuu uuuu uuuu uuuu
CA4H 15h xxxx xxxx uuuu uuuu uuuu uuuu
TCON3 16h -000 0000 -000 0000 -uuu uuuu
Unimplemented
17h ---- ---- ---- ---- ---- ----
Bank 8
DDRH 10h 1111 1111 1111 1111 uuuu uuuu
PORTH
(4)
11h xxxx xxxx uuuu uuuu uuuu uuuu
DDRJ 12h 1111 1111 1111 1111 uuuu uuuu
PORTJ
(4)
13h xxxx xxxx uuuu uuuu uuuu uuuu
Unbanked
PRODL 18h xxxx xxxx uuuu uuuu uuuu uuuu
PRODH 19h xxxx xxxx uuuu uuuu uuuu uuuu
TABLE 5-4: INITIALIZATION CONDITIONS FOR SPECIAL FUNCTION REGISTERS (CONTINUED)
Register Address
Power-on Reset
Brown-out Reset
MCLR
Reset
WDT Reset
Wake-up from SLEEP
through Interrupt
Legend: u = unchanged,
x = unknown, - = unimplemented, read as '0', q = value depends on condition
Note 1: One or more bits in INTSTA, PIR1, PIR2 will be affected (to cause wake-up).
2: When the wake-up is due to an interrupt and the GLINTD bit is cleared, the PC is loaded with the interrupt
vector.
3: See Table 5-3 for RESET value of specific condition.
4: This is the value that will be in the port output latch.
5: When the device is configured for Microprocessor or Extended Microcontroller mode, the operation of this
port does not rely on these registers.
6: On any device RESET, these pins are configured as inputs.