Datasheet

PIC16F882/883/884/886/887
DS41291F-page 26 © 2009 Microchip Technology Inc.
TABLE 2-1: PIC16F882/883/884/886/887 SPECIAL FUNCTION REGISTERS SUMMARY BANK 0
Addr Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Value on
POR, BOR
Page
Bank 0
00h INDF Addressing this location uses contents of FSR to address data memory (not a physical register) xxxx xxxx 37,217
01h TMR0 Timer0 Module Register xxxx xxxx 73,217
02h PCL Program Counter’s (PC) Least Significant Byte 0000 0000 37,217
03h STATUS IRP RP1 RP0 TO
PD ZDCC0001 1xxx 29,217
04h FSR Indirect Data Memory Address Pointer xxxx xxxx 37,217
05h PORTA
(3)
RA7 RA6 RA5 RA4 RA3 RA2 RA1 RA0 xxxx xxxx 39,217
06h PORTB
(3)
RB7 RB6 RB5 RB4 RB3 RB2 RB1 RB0 xxxx xxxx 48,217
07h PORTC
(3)
RC7 RC6 RC5 RC4 RC3 RC2 RC1 RC0 xxxx xxxx 53,217
08h PORTD
(3,4)
RD7 RD6 RD5 RD4 RD3 RD2 RD1 RD0 xxxx xxxx 57,217
09h PORTE
(3)
— — — —RE3RE2
(4)
RE1
(4)
RE0
(4)
---- xxxx 59,217
0Ah PCLATH
— — — Write Buffer for upper 5 bits of Program Counter ---0 0000 37,217
0Bh INTCON GIE PEIE T0IE INTE RBIE T0IF INTF RBIF
(1)
0000 000x 31,217
0Ch PIR1
— ADIF RCIF TXIF SSPIF CCP1IF TMR2IF TMR1IF -000 0000 34,217
0Dh PIR2
OSFIF C2IF C1IF EEIF BCLIF ULPWUIF —CCP2IF0000 00-0 35,217
0Eh TMR1L Holding Register for the Least Significant Byte of the 16-bit TMR1 Register xxxx xxxx 76,217
0Fh TMR1H Holding Register for the Most Significant Byte of the 16-bit TMR1 Register xxxx xxxx 76,217
10h T1CON
T1GINV TMR1GE T1CKPS1 T1CKPS0 T1OSCEN T1SYNC TMR1CS TMR1ON 0000 0000 79,217
11h TMR2 Timer2 Module Register 0000 0000 81,217
12h T2CON
— TOUTPS3 TOUTPS2 TOUTPS1 TOUTPS0 TMR2ON T2CKPS1 T2CKPS0 -000 0000 82,217
13h SSPBUF Synchronous Serial Port Receive Buffer/Transmit Register xxxx xxxx 183,217
14h SSPCON
(2)
WCOL SSPOV SSPEN CKP SSPM3 SSPM2 SSPM1 SSPM0 0000 0000 181,217
15h CCPR1L Capture/Compare/PWM Register 1 Low Byte (LSB) xxxx xxxx 126,217
16h CCPR1H Capture/Compare/PWM Register 1 High Byte (MSB) xxxx xxxx 126,217
17h CCP1CON P1M1 P1M0 DC1B1 DC1B0 CCP1M3 CCP1M2 CCP1M1 CCP1M0 0000 0000 124,217
18h RCSTA SPEN RX9 SREN CREN ADDEN FERR OERR RX9D 0000 000x 161,217
19h TXREG EUSART Transmit Data Register 0000 0000 153,217
1Ah RCREG EUSART Receive Data Register 0000 0000 158,217
1Bh CCPR2L Capture/Compare/PWM Register 2 Low Byte (LSB) xxxx xxxx 126,217
1Ch
CCPR2H Capture/Compare/PWM Register 2 High Byte (MSB) xxxx xxxx
126,218
1Dh
CCP2CON
— —
DC2B1 DC2B0 CCP2M3 CCP2M2 CCP2M1 CCP2M0 --00 0000 125,218
1Eh ADRESH A/D Result Register High Byte xxxx xxxx 99,218
1Fh ADCON0 ADCS1 ADCS0 CHS3 CHS2 CHS1 CHS0 GO/DONE
ADON 0000 0000 104,218
Legend: – = Unimplemented locations read as ‘0’, u = unchanged, x = unknown, q = value depends on condition, shaded = unimplemented
Note 1: MCLR
and WDT Reset do not affect the previous value data latch. The RBIF bit will be cleared upon Reset but will set again if the
mismatch exists.
2: When SSPCON register bits SSPM<3:0> = 1001, any reads or writes to the SSPADD SFR address are accessed through the SSPMSK
register. See Registers • and 13-4 for more detail.
3: Port pins with analog functions controlled by the ANSEL and ANSELH registers will read ‘0’ immediately after a Reset even though the
data latches are either undefined (POR) or unchanged (other Resets).
4: PIC16F884/PIC16F887 only.