Datasheet

PIC16F882/883/884/886/887
DS41291G-page 108  2006-2012 Microchip Technology Inc.
9.2.7 ADC REGISTER DEFINITIONS
The following registers are used to control the opera-
tion of the ADC.
REGISTER DEFINITIONS: ADC CONTROL
Note: For ANSEL and ANSELH registers, see
Register 3-3 and Register 3-4,
respectively.
REGISTER 9-1: ADCON0: A/D CONTROL REGISTER 0
R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0
ADCS1 ADCS0 CHS3 CHS2 CHS1 CHS0 GO/DONE
ADON
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown
bit 7-6 ADCS<1:0>: A/D Conversion Clock Select bits
00 = F
OSC/2
01 = F
OSC/8
10 = F
OSC/32
11 = F
RC (clock derived from a dedicated internal oscillator = 500 kHz max)
bit 5-2 CHS<3:0>: Analog Channel Select bits
0000 = AN0
0001 = AN1
0010 = AN2
0011 = AN3
0100 = AN4
0101 = AN5
0110 = AN6
0111 = AN7
1000 = AN8
1001 = AN9
1010 = AN10
1011 = AN11
1100 = AN12
1101 = AN13
1110 = CV
REF
1111 = Fixed Ref (0.6V fixed voltage reference)
bit 1 GO/DONE: A/D Conversion Status bit
1 = A/D conversion cycle in progress. Setting this bit starts an A/D conversion cycle.
This bit is automatically cleared by hardware when the A/D conversion has completed.
0 = A/D conversion completed/not in progress
bit 0 ADON: ADC Enable bit
1 = ADC is enabled
0 = ADC is disabled and consumes no operating current