Datasheet

PIC16F87XA
DS39582C-page 38  2001-2013 Microchip Technology Inc.
An example of the complete four-word write sequence
is shown in Example 3-4. The initial address is loaded
into the EEADRH:EEADR register pair; the four words
of data are loaded using indirect addressing.
EXAMPLE 3-4: WRITING TO FLASH PROGRAM MEMORY
; This write routine assumes the following:
;
; 1. A valid starting address (the least significant bits = ‘00’)is loaded in ADDRH:ADDRL
; 2. The 8 bytes of data are loaded, starting at the address in DATADDR
; 3. ADDRH, ADDRL and DATADDR are all located in shared data memory 0x70 - 0x7f
;
BSF STATUS,RP1 ;
BCF STATUS,RP0 ; Bank 2
MOVF ADDRH,W ; Load initial address
MOVWF EEADRH ;
MOVF ADDRL,W ;
MOVWF EEADR ;
MOVF DATAADDR,W ; Load initial data address
MOVWF FSR ;
LOOP MOVF INDF,W ; Load first data byte into lower
MOVWF EEDATA ;
INCF FSR,F ; Next byte
MOVF INDF,W ; Load second data byte into upper
MOVWF EEDATH ;
INCF FSR,F ;
BSF STATUS,RP0 ; Bank 3
BSF EECON1,EEPGD ; Point to program memory
BSF EECON1,WREN ; Enable writes
BCF INTCON,GIE ; Disable interrupts (if using)
MOVLW 55h ; Start of required write sequence:
MOVWF EECON2 ; Write 55h
MOVLW AAh ;
MOVWF EECON2 ; Write AAh
BSF EECON1,WR ; Set WR bit to begin write
NOP ; Any instructions here are ignored as processor
; halts to begin write sequence
NOP ; processor will stop here and wait for write complete
; after write processor continues with 3rd instruction
BCF EECON1,WREN ; Disable writes
BSF INTCON,GIE ; Enable interrupts (if using)
BCF STATUS,RP0 ; Bank 2
INCF EEADR,F ; Increment address
MOVF EEADR,W ; Check if lower two bits of address are ‘00’
ANDLW 0x03 ; Indicates when four words have been programmed
XORLW 0x03 ;
BTFSC STATUS,Z ; Exit if more than four words,
GOTO LOOP ; Continue if less than four words
Required
Sequence