Datasheet
2001-2013 Microchip Technology Inc. DS39582C-page 179
PIC16F87XA
VOL Output Low Voltage
D080 I/O ports — — 0.6 V IOL = 8.5 mA, VDD = 4.5V,
-40C to +85C
D083 OSC2/CLKO (RC osc config) — — 0.6 V I
OL = 1.6 mA, VDD = 4.5V,
-40C to +85C
V
OH Output High Voltage
D090 I/O ports
(3)
VDD – 0.7 — — V IOH = -3.0 mA, VDD = 4.5V,
-40C to +85C
D092 OSC2/CLKO (RC osc config) V
DD – 0.7 — — V IOH = -1.3 mA, VDD = 4.5V,
-40C to +85C
D150* V
OD Open-Drain High Voltage — — 8.5 V RA4 pin
Capacitive Loading Specs on
Output Pins
D100 C
OSC2 OSC2 pin — — 15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1
D101
D102
C
IO
CB
All I/O pins and OSC2 (RC mode)
SCL, SDA (I
2
C mode)
—
—
—
—
50
400
pF
pF
Data EEPROM Memory
D120 E
D Endurance 100K 1M — E/W -40C to +85C
D121 VDRW VDD for read/write VMIN — 5.5 V Using EECON to read/write,
V
MIN = min. operating voltage
D122 T
DEW Erase/write cycle time — 4 8 ms
Program Flash Memory
D130 EP Endurance 10K 100K — E/W -40C to +85C
D131 V
PR VDD for read VMIN —5.5 VVMIN = min. operating voltage
D132A VDD for erase/write VMIN — 5.5 V Using EECON to read/write,
V
MIN = min. operating voltage
D133 T
PEW Erase/Write cycle time — 4 8 ms
17.2 DC Characteristics: PIC16F873A/874A/876A/877A (Industrial, Extended)
PIC16LF873A/874A/876A/877A (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Operating voltage V
DD range as described in DC specification
(Section 17.1)
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC16F87XA be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.