Datasheet

PIC16CR83/84 PIC16F8X
 1996-2013 Microchip Technology Inc. DS30430D-page 11-95
FIGURE 11-4: CLKOUT AND I/O TIMING
TABLE 11-4 CLKOUT AND I/O TIMING REQUIREMENTS
Parameter
No. Sym Characteristic Min Typ† Max Units Conditions
10 TosH2ckL OSC1 to CLKOUT PIC16CR8X — 15 30 * ns Note 1
10A PIC16LCR8X — 15 120 * ns Note 1
11 TosH2ckH OSC1 to CLKOUT PIC16CR8X — 15 30 * ns Note 1
11A PIC16LCR8X — 15 120 * ns Note 1
12 TckR CLKOUT rise time PIC16CR8X — 15 30 * ns Note 1
12A PIC16LCR8X — 15 100 * ns Note 1
13 TckF CLKOUT fall time PIC16CR8X — 15 30 * ns Note 1
13A PIC16LCR8X — 15 100 * ns Note 1
14 TckL2ioV CLKOUT  to Port out valid — — 0.5T
CY +20 * ns Note 1
15 TioV2ckH Port in valid before PIC16CR8X 0.30T
CY + 30 * — — ns Note 1
CLKOUT  PIC16LCR8X 0.30T
CY + 80 * — — ns Note 1
16 TckH2ioI Port in hold after CLKOUT  0 * — — ns Note 1
17 TosH2ioV OSC1 (Q1 cycle) to PIC16CR8X — — 125 * ns
Port out valid PIC16LCR8X — — 250 * ns
18 TosH2ioI OSC1 (Q2 cycle) to
Port input invalid (I/O
in hold time)
PIC16CR8X 10 * — — ns
PIC16LCR8X 10 * — — ns
19 TioV2osH Port input valid to
OSC1(I/O in setup
time)
PIC16CR8X -75 * — — ns
PIC16LCR8X -175 * — — ns
20 TioR Port output rise time PIC16CR8X — 10 35 * ns
20A PIC16LCR8X — 10 70 * ns
21 TioF Port output fall time PIC16CR8X — 10 35 * ns
21A PIC16LCR8X — 10 70 * ns
22 Tinp INT pin high PIC16CR8X 20 * — — ns
22A or low time PIC16LCR8X 55 * — — ns
23 Trbp RB7:RB4 change INT PIC16CR8X T
OSC §— — ns
23A high or low time PIC16LCR8X T
OSC §— — ns
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5.0V, 25C unless otherwise stated. These parameters are for design guidance only
and are not tested.
§ By design
Note 1: Measurements are taken in RC Mode where CLKOUT output is 4 x T
OSC.
OSC1
CLKOUT
I/O Pin
(input)
I/O Pin
(output)
Q4
Q1
Q2 Q3
10
13
14
17
20, 21
22
23
19
18
15
11
12
16
old value
new value
Note: All tests must be done with specified capacitive loads (Figure 11-2) 50 pF on I/O pins and CLKOUT.