Datasheet
2001-2013 Microchip Technology Inc. DS39598F-page 5
PIC16F818/819
1.0 DEVICE OVERVIEW
This document contains device specific information for
the operation of the PIC16F818/819 devices. Additional
information may be found in the “PIC
®
Mid-Range MCU
Family Reference Manual” (DS33023) which may be
downloaded from the Microchip web site. The Reference
Manual should be considered a complementary docu-
ment to this data sheet and is highly recommended
reading for a better understanding of the device architec-
ture and operation of the peripheral modules.
The PIC16F818/819 belongs to the Mid-Range family
of the PIC
®
devices. The devices differ from each other
in the amount of Flash program memory, data memory
and data EEPROM (see Table 1-1). A block diagram of
the devices is shown in Figure 1-1. These devices con-
tain features that are new to the PIC16 product line:
• Internal RC oscillator with eight selectable
frequencies, including 31.25 kHz, 125 kHz,
250 kHz, 500 kHz, 1 MHz, 2 MHz, 4 MHz and
8 MHz. The INTRC can be configured as the
system clock via the configuration bits. Refer to
Section 4.5 “Internal Oscillator Block” and
Section 12.1 “Configuration Bits” for further
details.
• The Timer1 module current consumption has
been greatly reduced from 20 A (previous PIC16
devices) to 1.8 A typical (32 kHz at 2V), which is
ideal for real-time clock applications. Refer to
Section 6.0 “Timer0 Module” for further details.
• The amount of oscillator selections has increased.
The RC and INTRC modes can be selected with
an I/O pin configured as an I/O or a clock output
(F
OSC/4). An external clock can be configured
with an I/O pin. Refer to Section 4.0 “Oscillator
Configurations” for further details.
TABLE 1-1: AVAILABLE MEMORY IN
PIC16F818/819 DEVICES
There are 16 I/O pins that are user configurable on a
pin-to-pin basis. Some pins are multiplexed with other
device functions. These functions include:
• External Interrupt
• Change on PORTB Interrupt
• Timer0 Clock Input
• Low-Power Timer1 Clock/Oscillator
• Capture/Compare/PWM
• 10-bit, 5-channel Analog-to-Digital Converter
• SPI/I
2
C
•MCLR (RA5) can be configured as an Input
Table 1-2 details the pinout of the devices with
descriptions and details for each pin.
Device
Program
Flash
Data
Memory
Data
EEPROM
PIC16F818 1K x 14 128 x 8 128 x 8
PIC16F819 2K x14 256 x 8 256 x 8
Device
Program
Flash
Data
Memory
Data
EEPROM