Datasheet
2003-2013 Microchip Technology Inc. DS30498D-page 87
PIC16F7X7
9.0 CAPTURE/COMPARE/PWM
MODULES
Each Capture/Compare/PWM (CCP) module contains
a 16-bit register which can operate as a:
• 16-bit Capture register
• 16-bit Compare register
• PWM Master/Slave Duty Cycle register
The CCP1, CCP2 and CCP3 modules are identical in
operation, with the exception being the operation of the
special event trigger. Table 9-1 and Table 9-2 show the
resources and interactions of the CCP module(s). In
the following sections, the operation of a CCP module
is described with respect to CCP1. CCP2 and CCP3
operate the same as CCP1, except where noted.
9.1 CCP1 Module
Capture/Compare/PWM Register 1 (CCPR1) is
comprised of two 8-bit registers: CCPR1L (low byte)
and CCPR1H (high byte). The CCP1CON register con-
trols the operation of CCP1. The special event trigger
is generated by a compare match and will clear both
TMR1H and TMR1L registers.
9.2 CCP2 Module
Capture/Compare/PWM Register 2 (CCPR2) is com-
prised of two 8-bit registers: CCPR2L (low byte) and
CCPR2H (high byte). The CCP2CON register controls
the operation of CCP2. The special event trigger is gen-
erated by a compare match; it will clear both TMR1H and
TMR1L registers and start an A/D conversion (if the A/D
module is enabled).
Additional information on CCP modules is available in
the “PIC
®
Mid-Range MCU Family Reference Manual”
(DS33023) and in Application Note AN594 “Using the
CCP Module(s)” (DS00594).
9.3 CCP3 Module
Capture/Compare/PWM Register 3 (CCPR3) is com-
prised of two 8-bit registers: CCPR3L (low byte) and
CCPR3H (high byte). The CCP3CON register controls
the operation of CCP3.
TABLE 9-1: CCP MODE – TIMER
RESOURCES REQUIRED
TABLE 9-2: INTERACTION OF TWO CCP MODULES
CCP Mode Timer Resource
Capture
Compare
PWM
Timer1
Timer1
Timer2
CCPx Mode CCPy Mode Interaction
Capture Capture Same TMR1 time base.
Capture Compare Same TMR1 time base.
Compare Compare Same TMR1 time base.
PWM PWM The PWMs will have the same frequency and update rate (TMR2 interrupt).
The rising edges are aligned.
PWM Capture None.
PWM Compare None.