Datasheet

 2003-2013 Microchip Technology Inc. DS30498D-page 217
PIC16F7X7
IIL Input Leakage Current
(2, 3)
D060 I/O ports — — 1 AVSS VPIN VDD,
pin at high-impedance
D061 MCLR
, RA4/T0CKI — — 5 AVSS VPIN VDD
D063 OSC1 — — 5 AVSS VPIN VDD,
XT, HS and LP oscillator
configuration
VOL Output Low Voltage
D080 I/O ports — — 0.6 V IOL = 8.5 mA, VDD = 4.5V,
-40C to +125C
D083 OSC2/CLKO
(RC oscillator configuration)
—
—
—
—
0.6
0.6
V
V
I
OL = 1.6 mA, VDD = 4.5V,
-40C to +125C
I
OL = 1.2 mA, VDD = 4.5V,
-40C to +125C
V
OH Output High Voltage
D090 I/O ports (Note 3) VDD – 0.7 — — V IOH = -3.0 mA, VDD = 4.5V,
-40C to +125C
D092 OSC2/CLKO
(RC oscillator configuration)
V
DD – 0.7
V
DD – 0.7
—
—
—
—
V
V
I
OH = -1.3 mA, VDD = 4.5V,
-40C to +125C
I
OH = -1.0 mA, VDD = 4.5V,
-40C to +125C
D150* V
OD Open-Drain High Voltage — — 12 V RA4 pin
Capacitive Loading Specs
on Output Pins
D100 C
OSC2 OSC2 pin — — 15 pF In XT, HS and LP modes
when external clock is used
to drive OSC1
D101 CIO All I/O pins and OSC2
(in RC mode)
— — 50 pF
D102 C
B SCL, SDA in I
2
C™ mode — — 400 pF
Program Flash Memory
D130 E
P Endurance 100 1000 — E/W 25C at 5V
D131 VPR VDD for Read 2.0 — 5.5 V
18.4 DC Characteristics: PIC16F737/747/767/777 (Industrial, Extended)
PIC16LF737/747/767/777 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial
-40°C  T
A  +125°C for extended
Operating voltage V
DD range as described in
Section 18.1 “DC Characteristics”.
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC16F7X7 be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.