Datasheet

PIC16F7X7
DS30498C-page 218  2004 Microchip Technology Inc.
18.4 DC Characteristics: PIC16F737/747/767/777 (Industrial, Extended)
PIC16LF737/747/767/777 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
-40°C ≤ T
A ≤ +125°C for extended
Operating voltage V
DD range as described in
Section 18.1 “DC Characteristics”.
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
V
IL Input Low Voltage
I/O ports:
D030 with TTL buffer V
SS —0.15
V
DD
V For entire VDD range
D030A V
SS — 0.8V V 4.5V ≤ VDD ≤ 5.5V
D031 with Schmitt Trigger buffer V
SS — 0.2 VDD V
D032 MCLR, OSC1 (in RC mode) VSS — 0.2 VDD V
D033 OSC1 (in XT and LP modes) VSS —0.3VV(Note 1)
OSC1 (in HS mode) V
SS — 0.3 VDD V
Ports RC3 and RC4: —
D034 with Schmitt Trigger buffer VSS — 0.3 VDD V For entire VDD range
D034A with SMBus -0.5 — 0.6 V For V
DD = 4.5 to 5.5V
VIH Input High Voltage
I/O ports: —
D040 with TTL buffer 2.0 — V
DD V4.5V ≤ VDD ≤ 5.5V
D040A 0.25 VDD + 0.8V — VDD V For entire VDD range
D041 with Schmitt Trigger buffer 0.8 VDD —VDD V For entire VDD range
D042 MCLR
0.8 VDD —VDD V
D042A OSC1 (in XT and LP modes) 1.6V — VDD V (Note 1)
OSC1 (in HS mode) 0.7 VDD —VDD V
D043 OSC1 (in RC mode) 0.9 V
DD —VDD V
Ports RC3 and RC4:
D044 with Schmitt Trigger buffer 0.7 VDD —VDD V For entire VDD range
D044A with SMBus 1.4 — 5.5 V For V
DD = 4.5 to 5.5V
D070 I
PURB PORTB Weak Pull-up
Current
50 250 400 µAVDD = 5V, VPIN = VSS,
-40°C
TO +85°C
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC16F7X7 be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.