Datasheet

2002 Microchip Technology Inc. DS30325B-page 123
PIC16F7X
15.2 DC Characteristics: PIC16F73/74/76/77 (Industrial, Extended)
PIC16LF73/74/76/77 (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Operating voltage V
DD range as described in DC Specification,
Section 15.1.
Param
No.
Sym Characteristic Min Typ Max Units Conditions
V
IL Input Low Voltage
I/O ports:
D030 with TTL buffer V
SS 0.15VDD V For entire VDD range
D030A VSS 0.8V V 4.5V VDD 5.5V
D031 with Schmitt Trigger buffer V
SS 0.2VDD V
D032 MCLR
, OSC1 (in RC mode) VSS 0.2VDD V (Note 1)
D033 OSC1 (in XT and LP mode) VSS 0.3V V
OSC1 (in HS mode) V
SS 0.3VDD V
VIH Input High Voltage
I/O ports:
D040 with TTL buffer 2.0 V
DD V4.5V VDD 5.5V
D040A 0.25VDD
+ 0.8V
VDD V For entire VDD range
D041 with Schmitt Trigger buffer 0.8V
DD VDD V For entire VDD range
D042 MCLR
0.8VDD VDD V
D042A OSC1 (in XT and LP mode) 1.6V V
DD V
OSC1 (in HS mode) 0.7V
DD VDD V
D043 OSC1 (in RC mode) 0.9VDD VDD V (Note 1)
D070 I
PURB PORTB Weak Pull-up Current 50 250 400 µAVDD = 5V, VPIN = VSS
IIL Input Leakage Current (Notes 2, 3)
D060 I/O ports ——±1 µAVss VPIN VDD, pin at
hi-impedance
D061 MCLR, RA4/T0CKI ——±5 µAVss VPIN VDD
D063 OSC1 ——±5 µAVss VPIN VDD, XT, HS and LP
osc configuration
* These parameters are characterized but not tested.
Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16F7X be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.