Datasheet

PIC16F72
DS39597C-page 92 © 2007 Microchip Technology Inc.
VOL Output Low Voltage
D080 I/O ports — — 0.6 V IOL = 8.5 mA, VDD = 4.5V,
-40°C to +85°C
D083 OSC2/CLKO (RC osc config) — — 0.6 V IOL = 1.6 mA, VDD = 4.5V,
-40°C to +85°C
V
OH Output High Voltage
D090 I/O ports (Note 3) VDD - 0.7 — — V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D092 OSC2/CLKO (RC osc config) VDD - 0.7 — — V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D150* V
OD Open Drain High Voltage ——12VRA4 pin
Capacitive Loading Specs on Output Pins
D100 COSC2 OSC2 pin — — 15 pF In XT, HS and LP modes
when external clock is used
to drive OSC1
D101 C
IO All I/O pins and OSC2
(in RC mode)
— — 50 pF
D102 C
B
SCL, SDA in I
2
C mode
——400pF
Program FLASH Memory
D130 E
P Endurance 100 1000 — E/W 25°C at 5V
D131 V
PR VDD for read 2.0 — 5.5 V
14.2 DC Characteristics: PIC16F72 (Industrial, Extended)
PIC16LF72 (Industrial) (Continued)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
-40°C ≤ T
A ≤ +125°C for extended
Operating voltage V
DD range as described in DC Specification,
Section 14.1.
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the
PIC16F72 be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.