Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller SSOP 28 8-Bit 20 MHz I/O number 22

100

PIC16F72

14.2 DC Characteristics: PIC16F72 (Industrial, Extended)

PIC16LF72 (Industrial)

DC CHARACTERISTICS

Standard Operating Conditions (unless otherwise stated)

Operating temperature -40°C ≤ T

A ≤ +85°C for industrial

-40°C ≤ T

A ≤ +125°C for extended

Operating voltage V

DD range as described in DC Specification,

Section 14.1.

Param

No.

Sym Characteristic Min Typ† Max Units Conditions

IL Input Low Voltage

I/O ports

D030 with TTL buffer V

SS —0.15 VDD V For entire VDD range

D030A V

SS —0.8V V4.5V ≤ VDD ≤ 5.5V

D031 with Schmitt Trigger buffer V

SS — 0.2 VDD V

D032 MCLR, OSC1 (in RC mode) VSS — 0.2 VDD V

D033 OSC1 (in XT and LP mode) V

SS —0.3V V(Note 1)

OSC1 (in HS mode) V

SS — 0.3 VDD V (Note 1)

VIH Input High Voltage

I/O ports

D040 with TTL buffer 2.0 — V

DD V4.5V ≤ VDD ≤ 5.5V

D040A 0.25 V

DD + 0.8V — VDD V For entire VDD range

D041 with Schmitt Trigger buffer 0.8 V

DD —VDD V For entire VDD range

D042 MCLR 0.8 VDD —VDD V

D042A OSC1 (in XT and LP mode) 1.6V — V

DD V (Note 1)

OSC1 (in HS mode) 0.7 V

DD —VDD V (Note 1)

D043 OSC1 (in RC mode) 0.9 V

DD —VDD V

D070 IPURB PORTB Weak Pull-up Current 50 250 400 μAVDD = 5V, VPIN = VSS

IIL Input Leakage Current (Notes 2, 3)

D060 I/O ports — — ±1 μAVss ≤ V

PIN ≤ VDD, Pin at

hi-impedance

D061 MCLR

, RA4/T0CKI — — ±5 μAVss ≤ VPIN ≤ VDD

D063 OSC1 — — ±5 μAVss ≤ VPIN ≤ VDD, XT, HS

and LP osc configuration

* These parameters are characterized but not tested.

† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only

and are not tested.

Note 1: In RC oscillator configuration, the OSC1/CLKI pin is a Schmitt Trigger input. It is not recommended that the

PIC16F72 be driven with external clock in RC mode.

2: The leakage current on the MCLR

pin is strongly dependent on the applied voltage level. The specified levels

represent normal operating conditions. Higher leakage current may be measured at different input voltages.

3: Negative current is defined as current sourced by the pin.