Datasheet

PIC16F72

2.2.2.5 PIR1 Register

This register contains the individual flag bits for the

Peripheral interrupts.

U-0 R/W-0 U-0 U-0 R/W-0 R/W-0 R/W-0 R/W-0

—ADIF — — SSPIF CCP1IF TMR2IF TMR1IF

bit 7 bit 0

bit 7 Unimplemented: Read as ‘0’

bit 6 ADIF: A/D Converter Interrupt Flag bit

1 = An A/D conversion completed

0 = The A/D conversion is not complete

bit 5-4 Unimplemented: Read as ‘0’

bit 3 SSPIF: Synchronous Serial Port (SSP) Interrupt Flag bit

1 = The SSP interrupt condition has occurred, and must be cleared in software before returning

from the Interrupt Service Routine.

The conditions that will set this bit are a transmission/reception has taken place.

0 = No SSP interrupt condition has occurred

bit 2 CCP1IF: CCP1 Interrupt Flag bit

Capture mode:

1 = A TMR1 register capture occurred (must be cleared in software)

0 = No TMR1 register capture occurred

Compare mode:

1 = A TMR1 register compare match occurred (must be cleared in software)

0 = No TMR1 register compare match occurred

PWM mode:

Unused in this mode

bit 1 TMR2IF: TMR2 to PR2 Match Interrupt Flag bit

1 = TMR2 to PR2 match occurred (must be cleared in software)

0 = No TMR2 to PR2 match occurred

bit 0 TMR1IF: TMR1 Overflow Interrupt Flag bit

1 = TMR1 register overflowed (must be cleared in software)

0 = TMR1 register did not overflow

Legend:

R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’

- n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown