Datasheet

 2003 Microchip Technology Inc. Preliminary DS41206A-page 15

PIC16F716

2.2.2.5 PIR1 Register

This register contains the individual flag bits for the

peripheral interrupts.

Note: Interrupt flag bits get set when an interrupt

condition occurs, regardless of the state of

its corresponding enable bit or the global

enable bit, GIE (INTCON<7>). User

software should ensure the appropriate

interrupt flag bits are clear prior to

enabling an interrupt.

U-0 R/W-0 U-0 U-0 U-0 R/W-0 R/W-0 R/W-0

—ADIF— — — CCP1IF TMR2IF TMR1IF

bit 7 bit 0

bit 7 Unimplemented: Read as ‘0’

bit 6 ADIF: A/D Converter Interrupt Flag bit

1 = An A/D conversion completed (must be cleared in software)

0 = The A/D conversion is not complete

bit 5-3 Unimplemented: Read as ‘0’

bit 2 CCP1IF: CCP1 Interrupt Flag bit

Capture Mode

1 = A TMR1 register capture occurred (must be cleared in software)

0 = No TMR1 register capture occurred

Compare Mode

1 = A TMR1 register compare match occurred (must be cleared in software)

0 = No TMR1 register compare match occurred

PWM Mode

Unused in this mode

bit 1 TMR2IF: TMR2 to PR2 Match Interrupt Flag bit

1 = TMR2 to PR2 match occurred (must be cleared in software)

0 = No TMR2 to PR2 match occurred

bit 0 TMR1IF: TMR1 Overflow Interrupt Flag bit

1 = TMR1 register overflowed (must be cleared in software)

0 = TMR1 register did not overflow

Legend:

R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’

-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown