Datasheet

PIC16F684

2.2.2.5 PIR1 Register

The PIR1 register contains the peripheral interrupt flag

bits, as shown in Register 2-5.

Note: Interrupt flag bits are set when an interrupt

condition occurs, regardless of the state of

its corresponding enable bit or the global

enable bit, GIE of the INTCON register. User

software should ensure the appropriate

interrupt flag bits are clear prior to enabling

an interrupt.

R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0 R/W-0

EEIF ADIF CCP1IF C2IF C1IF OSFIF TMR2IF TMR1IF

bit 7 bit 0

Legend:

R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’

-n = Value at POR ‘1’ = Bit is set ‘0’ = Bit is cleared x = Bit is unknown

bit 7 EEIF: EEPROM Write Operation Interrupt Flag bit

1 = The write operation completed (must be cleared in software)

0 = The write operation has not completed or has not been started

bit 6 ADIF: A/D Interrupt Flag bit

1 = A/D conversion complete

0 = A/D conversion has not completed or has not been started

bit 5 CCP1IF: CCP1 Interrupt Flag bit

Capture mod

1 = A TMR1 register capture occurred (must be cleared in software)

0 = No TMR1 register capture occurred

Compare mode

1 = A TMR1 register compare match occurred (must be cleared in software)

0 = No TMR1 register compare match occurred

PWM mode

Unused in this mode

bit 4 C2IF: Comparator 2 Interrupt Flag bit

1 = Comparator 2 output has changed (must be cleared in software)

0 = Comparator 2 output has not changed

bit 3 C1IF: Comparator 1 Interrupt Flag bit

1 = Comparator 1 output has changed (must be cleared in software)

0 = Comparator 1 output has not changed

bit 2 OSFIF: Oscillator Fail Interrupt Flag bit

1 = System oscillator failed, clock input has changed to INTOSC (must be cleared in software)

0 = System clock operating

bit 1 TMR2IF: Timer2 to PR2 Match Interrupt Flag bit

1 = Timer2 to PR2 match occurred (must be cleared in software)

0 = Timer2 to PR2 match has not occurred

bit 0 TMR1IF: Timer1 Overflow Interrupt Flag bit

1 = Timer1 register overflowed (must be cleared in software)

0 = Timer1 has not overflowed