Datasheet

PIC16F684
DS41202F-page 132 © 2007 Microchip Technology Inc.
15.2 DC Characteristics: PIC16F684-I (Industrial)
PIC16F684-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ T
A ≤ +125°C for extended
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D010 Supply Current (I
DD)
(1, 2)
—1116μA2.0FOSC = 32 kHz
LP Oscillator mode
—1828μA3.0
—3554μA5.0
D011* — 140 240 μA2.0F
OSC = 1 MHz
XT Oscillator mode
— 220 380 μA3.0
— 380 550 μA5.0
D012 — 260 360 μA2.0F
OSC = 4 MHz
XT Oscillator mode
— 420 650 μA3.0
—0.81.1mA5.0
D013* — 130 220 μA2.0F
OSC = 1 MHz
EC Oscillator mode
— 215 360 μA3.0
— 360 520 μA5.0
D014 — 220 340 μA2.0F
OSC = 4 MHz
EC Oscillator mode
— 375 550 μA3.0
— 0.65 1.0 mA 5.0
D015 — 8 20 μA2.0F
OSC = 31 kHz
LFINTOSC mode
—1640μA3.0
—3165μA5.0
D016* — 340 450 μA2.0F
OSC = 4 MHz
HFINTOSC mode
— 500 700 μA3.0
—0.81.2mA5.0
D017 — 410 650 μA2.0F
OSC = 8 MHz
HFINTOSC mode
— 700 950 μA3.0
— 1.30 1.65 mA 5.0
D018 — 230 400 μA2.0F
OSC = 4 MHz
EXTRC mode
(3)
— 400 680 μA3.0
— 0.63 1.1 mA 5.0
D019 — 2.6 3.25 mA 4.5 FOSC = 20 MHz
HS Oscillator mode
— 2.8 3.35 mA 5.0
* These parameters are characterized but not tested.
† Data in ‘Typ’ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave,
from rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern and temperature, also have
an impact on the current consumption.
3: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can
be extended by the formula I
R = VDD/2REXT (mA) with REXT in kΩ.