Datasheet

PIC16F630/676

2.2.2.5 PIR1 Register

The PIR1 register contains the interrupt flag bits, as

shown in Register 2-5.

Note: Interrupt flag bits are set when an interrupt

condition occurs, regardless of the state of

its corresponding enable bit or the global

enable bit, GIE (INTCON<7>). User

software should ensure the appropriate

interrupt flag bits are clear prior to enabling

an interrupt.

R/W-0 R/W-0 U-0 U-0 R/W-0 U-0 U-0 R/W-0

EEIF ADIF — —CMIF— —TMR1IF

bit 7 bit 0

bit 7 EEIF: EEPROM Write Operation Interrupt Flag bit

1 = The write operation completed (must be cleared in software)

0 = The write operation has not completed or has not been started

bit 6 ADIF: A/D Converter Interrupt Flag bit (PIC16F676 only)

1 = The A/D conversion is complete (must be cleared in software)

0 = The A/D conversion is not complete

bit 5-4 Unimplemented: Read as ‘0’

bit 3 CMIF: Comparator Interrupt Flag bit

1 = Comparator input has changed (must be cleared in software)

0 = Comparator input has not changed

bit 2-1 Unimplemented: Read as ‘0’

bit 0 TMR1IF: TMR1 Overflow Interrupt Flag bit

1 = TMR1 register overflowed (must be cleared in software)

0 = TMR1 register did not overflow

Legend:

R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’

- n = Value at POR ’1’ = Bit is set ’0’ = Bit is cleared x = Bit is unknown