Datasheet

© 2007 Microchip Technology Inc. DS40039E-page 103
PIC16F630/676
FIGURE 12-11: PIC16F676 A/D CONVERSION TIMING (SLEEP MODE)
TABLE 12-10: PIC16F676 A/D CONVERSION REQUIREMENTS (SLEEP MODE)
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
130 TAD A/D Clock Period 1.6 — — μsVREF ≥ 3.0V
3.0* — — μsVREF full range
130 T
AD A/D Internal RC
Oscillator Period 3.0* 6.0 9.0* μs
ADCS<1:0> = 11 (RC mode)
At V
DD = 2.5V
2.0* 4.0 6.0* μsAt VDD = 5.0V
131 T
CNV Conversion Time
(not including
Acquisition Time)
(1)
—11—T
AD
132 TACQ Acquisition Time (Note 2)
5*
11.5
—
—
—
μs
μs The minimum time is the amplifier
settling time. This may be used if
the “new” input voltage has not
changed by more than 1 LSb (i.e.,
4.1 mV @ 4.096V) from the last
sampled voltage (as stored on
C
HOLD).
134 T
GO Q4 to A/D Clock
Start
—TOSC/2 + TCY — — If the A/D clock source is selected
as RC, a time of T
CY is added
before the A/D clock starts. This
allows the SLEEP instruction to be
executed.
* These parameters are characterized but not tested.
† Data in ‘Typ’ column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: ADRES register may be read on the following T
CY cycle.
2: See Table 7-1 for minimum conditions.
131
130
BSF ADCON0, GO
Q4
A/D CLK
A/D DATA
ADRES
ADIF
GO
SAMPLE
OLD_DATA
SAMPLING STOPPED
DONE
NEW_DATA
9 7 3210
Note 1: If the A/D clock source is selected as RC, a time of T
CY is added before the A/D clock starts. This allows the
SLEEP instruction to be executed.
134
6
8
132
1 TCY
(TOSC/2 + TCY)
(1)
1 TCY