Datasheet
© 2007 Microchip Technology Inc. DS41232D-page 23
PIC12F635/PIC16F636/639
TABLE 2-3: PIC16F636/639 SPECIAL FUNCTION REGISTERS SUMMARY BANK 0
Addr Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Value on
POR/BOR/
WUR
Page
Bank 0
00h INDF Addressing this location uses contents of FSR to address data memory
(not a physical register)
xxxx xxxx
32,137
01h TMR0 Timer0 Module Register xxxx xxxx
61,137
02h PCL Program Counter’s (PC) Least Significant Byte 0000 0000
32,137
03h STATUS IRP RP1 RP0 TO PD ZDCC0001 1xxx
26,137
04h FSR Indirect Data Memory Address Pointer xxxx xxxx
32,137
05h PORTA — — RA5 RA4 RA3 RA2 RA1 RA0 --xx xx00 48,137
06h — Unimplemented — —
07h PORTC
— — RC5 RC4 RC3 RC2 RC1 RC0 --xx xx00 57,137
08h — Unimplemented — —
09h — Unimplemented — —
0Ah PCLATH
— — — Write Buffer for upper 5 bits of Program Counter ---0 0000
32,137
0Bh INTCON GIE PEIE T0IE INTE RAIE T0IF INTF RAIF
(2)
0000 000x
28,137
0Ch PIR1 EEIF LVDIF CRIF C2IF C1IF OSFIF —TMR1IF0000 00-0
30,137
0Dh — Unimplemented — —
0Eh TMR1L Holding Register for the Least Significant Byte of the 16-bit TMR1 xxxx xxxx
64,137
0Fh TMR1H Holding Register for the Most Significant Byte of the 16-bit TMR1 xxxx xxxx
64,137
10h T1CON T1GINV TMR1GE T1CKPS1 T1CKPS0 T1OSCEN T1SYNC TMR1CS TMR1ON 0000 0000
68,137
11h — Unimplemented — —
12h — Unimplemented — —
13h — Unimplemented — —
14h — Unimplemented — —
15h — Unimplemented — —
16h — Unimplemented — —
17h — Unimplemented — —
18h WDTCON
— — — WDTPS3 WDTPS2 WDTPS1 WDTPS0 SWDTEN ---0 1000
144,137
19h CMCON0 C2OUT C1OUT C2INV C1INV CIS CM2 CM1 CM0 0000 0000
79,137
1Ah CMCON1 — — — — — — T1GSS C2SYNC ---- --10
82,137
1Bh — Unimplemented — —
1Ch — Unimplemented — —
1Dh — Unimplemented — —
1Eh — Unimplemented — —
1Fh — Unimplemented — —
Legend: – = Unimplemented locations read as ‘0’, u = unchanged, x = unknown, q = value depends on condition,
shaded = unimplemented
Note 1: Other (non Power-up) Resets include MCLR
Reset and Watchdog Timer Reset during normal operation.
2: MCLR
and WDT Reset do not affect the previous value data latch. The RAIF bit will be cleared upon Reset but will set
again if the mismatch exists.