Datasheet

PIC16F610/616/16HV610/616
DS41288F-page 152 © 2009 Microchip Technology Inc.
15.7 DC Characteristics: PIC16HV610/616-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +125°C for extended
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D020E Power-down Base
Current (IPD)
(2, 3)
PIC16HV610/616
—135200μA 2.0 WDT, BOR, Comparators, V
REF and
T1OSC disabled
—210280μA3.0
—260350μA4.5
D021E — 135 200 μA 2.0 WDT Current
(1)
—210285μA3.0
—265360μA4.5
D022E — 215 285 μA 3.0 BOR Current
(1)
—265360μA4.5
D023E — 240 360 μA 2.0 Comparator Current
(1)
, both
comparators enabled
—320440μA3.0
—370500μA4.5
D024E — 185 280 μA 2.0 Comparator Current
(1)
, single
comparator enabled
—265360μA3.0
—320430μA4.5
D025E — 165 235 μA2.0CV
REF Current
(1)
(high range)
—255330μA3.0
—330430μA4.5
D026E* — 175 245 μA2.0CV
REF Current
(1)
(low range)
—275350μA3.0
—355450μA4.5
D027E — 140 205 μA 2.0 T1OSC Current
(1)
, 32.768 kHz
—220290μA3.0
—270360μA4.5
D028E — 210 280 μA 3.0 A/D Current
(1)
, no conversion in
progress
—260350μA4.5
* These parameters are characterized but not tested.
† Data in “Typ” column is at 4.5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral Δ current can be determined by subtracting the base I
DD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: Shunt regulator is always enabled and always draws operating current.