Datasheet

© 2009 Microchip Technology Inc. DS41288F-page 151
PIC16F610/616/16HV610/616
15.6 DC Characteristics: PIC16HV610/616- I (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D020 Power-down Base
Current(IPD)
(2,3)
—135200μA 2.0 WDT, BOR, Comparators, V
REF and
T1OSC disabled
—210280μA3.0
PIC16HV610/616 — 260 350 μA4.5
D021 — 135 200 μA 2.0 WDT Current
(1)
—210285μA3.0
—265360μA4.5
D022 — 215 285 μA 3.0 BOR Current
(1)
—265360μA4.5
D023 — 240 340 μA 2.0 Comparator Current
(1)
, both
comparators enabled
—320420μA3.0
—370500μA4.5
D024 — 185 270 μA 2.0 Comparator Current
(1)
, single
comparator enabled
—265350μA3.0
—320430μA4.5
D025 — 165 235 μA2.0CV
REF Current
(1)
(high range)
—255330μA3.0
—330430μA4.5
D026* — 175 245 μA2.0CV
REF Current
(1)
(low range)
—275350μA3.0
—355450μA4.5
D027 — 140 205 μA 2.0 T1OSC Current
(1)
, 32.768 kHz
—220290μA3.0
—270360μA4.5
D028 — 210 280 μA 3.0 A/D Current
(1)
, no conversion in
progress
—260350μA4.5
* These parameters are characterized but not tested.
† Data in “Typ” column is at 4.5V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral Δ current can be determined by subtracting the base I
DD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: Shunt regulator is always enabled and always draws operating current.