Datasheet

PIC16F610/616/16HV610/616
DS41288F-page 150 © 2009 Microchip Technology Inc.
15.5 DC Characteristics: PIC16F610/616-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +125°C for extended
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
VDD Note
D020E Power-down Base
Current (IPD)
(2)
PIC16F610/616
— 0.05 4.0 μA 2.0 WDT, BOR, Comparators, VREF and
T1OSC disabled
— 0.15 5.0 μA3.0
— 0.35 8.5 μA5.0
D021E — 0.5 5.0 μA 2.0 WDT Current
(1)
—2.58.0μA3.0
—9.519 μA5.0
D022E — 5.0 15 μA 3.0 BOR Current
(1)
—6.019 μA5.0
D023E — 105 130 μA 2.0 Comparator Current
(1)
, both
comparators enabled
—110140μA3.0
—116150μA5.0
D024E — 50 70 μA 2.0 Comparator Current
(1)
, single
comparator enabled
—5575μA3.0
—6080μA5.0
D025E — 30 40 μA2.0CV
REF Current
(1)
(high range)
—4560μA3.0
—75105μA5.0
D026E* — 39 50 μA2.0CV
REF Current
(1)
(low range)
—5980μA3.0
—98130μA5.0
D027E — 5.5 16 μA 2.0 T1OSC Current
(1)
, 32.768 kHz
—7.018 μA3.0
—8.522 μA5.0
D028E — 0.2 6.5 μA 3.0 A/D Current
(1)
, no conversion in
progress
—0.3610 μA5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral Δ current can be determined by subtracting the base I
DD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.