Datasheet

© 2009 Microchip Technology Inc. DS41288F-page 149
PIC16F610/616/16HV610/616
15.4 DC Characteristics: PIC16F610/616- I (Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ T
A ≤ +85°C for industrial
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D020 Power-down Base
Current(IPD)
(2)
— 0.05 0.9 μA 2.0 WDT, BOR, Comparators, V
REF and
T1OSC disabled
— 0.15 1.2 μA3.0
PIC16F610/616 — 0.35 1.5 μA5.0
— 150 500 nA 3.0
-40°C ≤ TA ≤ +25°C for industrial
D021 — 0.5 1.5 μA 2.0 WDT Current
(1)
—2.54.0μA3.0
—9.517 μA5.0
D022 — 5.0 9 μA 3.0 BOR Current
(1)
—6.012 μA5.0
D023 — 105 115 μA 2.0 Comparator Current
(1)
, both
comparators enabled
— 110 125 μA3.0
— 116 140 μA5.0
D024 — 50 60 μA 2.0 Comparator Current
(1)
, single
comparator enabled
—5565μA3.0
—6075μA5.0
D025 — 30 40 μA2.0CV
REF Current
(1)
(high range)
—4560μA3.0
—75105μA5.0
D026* — 39 50 μA2.0CV
REF Current
(1)
(low range)
—5980μA3.0
—98130μA5.0
D027 — 5.5 10 μA 2.0 T1OSC Current
(1)
, 32.768 kHz
—7.012 μA3.0
—8.514 μA5.0
D028 — 0.2 1.6 μA 3.0 A/D Current
(1)
, no conversion in
progress.
— 0.36 1.9 μA5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this
peripheral is enabled. The peripheral Δ current can be determined by subtracting the base I
DD or IPD
current from this limit. Max values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is
measured with the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.