Datasheet

© 2009 Microchip Technology Inc. DS41288F-page 147
PIC16F610/616/16HV610/616
15.2 DC Characteristics: PIC16F610/616-I (Industrial)
PIC16F610/616-E (Extended)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C ≤ TA ≤ +85°C for industrial
-40°C ≤ T
A ≤ +125°C for extended
Param
No.
Device Characteristics Min Typ† Max Units
Conditions
V
DD Note
D010 Supply Current (I
DD)
(1, 2)
—
13 25
μA2.0FOSC = 32 kHz
LP Oscillator mode
PIC16F610/616 — 19 29 μA3.0
—3251μA5.0
D011* — 135 225 μA2.0F
OSC = 1 MHz
XT Oscillator mode
— 185 285 μA3.0
— 300 405 μA5.0
D012 — 240 360 μA2.0F
OSC = 4 MHz
XT Oscillator mode
— 360 505 μA3.0
— 0.66 1.0 mA 5.0
D013* — 75 110 μA2.0F
OSC = 1 MHz
EC Oscillator mode
— 155 255 μA3.0
— 345 530 μA5.0
D014 — 185 255 μA2.0F
OSC = 4 MHz
EC Oscillator mode
— 325 475 μA3.0
— 0.665 1.0 mA 5.0
D016* — 245 340 μA2.0F
OSC = 4 MHz
INTOSC mode
— 360 485 μA3.0
— 0.620 0.845 mA 5.0
D017 — 395 550 μA2.0F
OSC = 8 MHz
INTOSC mode
— 0.620 0.850 mA 3.0
— 1.2 1.6 mA 5.0
D018 — 175 235 μA2.0F
OSC = 4 MHz
EXTRC mode
(3)
— 285 390 μA3.0
— 530 750 μA5.0
D019 — 2.2 3.1 mA 4.5 F
OSC = 20 MHz
HS Oscillator mode
— 2.8 3.35 mA 5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave,
from rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern and temperature, also have
an impact on the current consumption.
3: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can
be extended by the formula I
R = VDD/2REXT (mA) with REXT in kΩ.