Datasheet

PIC16(L)F1946/47
DS41414D-page 256  2010-2012 Microchip Technology Inc.
24.4.4 SDAX HOLD TIME
The hold time of the SDAx pin is selected by the
SDAHT bit of the SSPxCON3 register. Hold time is the
time SDAx is held valid after the falling edge of SCLx.
Setting the SDAHT bit selects a longer 300 ns mini-
mum hold time and may help on buses with large
capacitance.
TABLE 24-2: I
2
C BUS TERMS
TERM Description
Transmitter The device which shifts data out
onto the bus.
Receiver The device which shifts data in
from the bus.
Master The device that initiates a transfer,
generates clock signals and termi-
nates a transfer.
Slave The device addressed by the mas-
ter.
Multi-master A bus with more than one device
that can initiate data transfers.
Arbitration Procedure to ensure that only one
master at a time controls the bus.
Winning arbitration ensures that
the message is not corrupted.
Synchronization Procedure to synchronize the
clocks of two or more devices on
the bus.
Idle No master is controlling the bus,
and both SDAx and SCLx lines are
high.
Active Any time one or more master
devices are controlling the bus.
Addressed
Slave
Slave device that has received a
matching address and is actively
being clocked by a master.
Matching
Address
Address byte that is clocked into a
slave that matches the value
stored in SSPxADD.
Write Request Slave receives a matching
address with R/W
bit clear, and is
ready to clock in data.
Read Request Master sends an address byte with
the R/W
bit set, indicating that it
wishes to clock data out of the
Slave. This data is the next and all
following bytes until a Restart or
Stop.
Clock Stretching When a device on the bus hold
SCLx low to stall communication.
Bus Collision Any time the SDAx line is sampled
low by the module while it is out-
putting and expected high state.