Datasheet

PIC16F193X/LF193X
DS41364D-page 452 Preliminary  2009 Microchip Technology Inc.
Power-down Base Current (I
PD)
(2)
D028 — 0.1 5 — A 1.8 A/D Current (Note 1, Note 3), no
conversion in progress
—0.1 6 — A3.0
D028 — 16 35 — A 1.8 A/D Current (Note 1, Note 3), no
conversion in progress
— 21 40 — A 3.0
— 25 50 — A 5.0
D029 — 250 — — A 1.8 A/D Current (Note 1, Note 3),
conversion in progress
—250 — — A3.0
D029 — 280 — — A 1.8 A/D Current (Note 1, Note 3,
Note 4), conversion in progress
— 280 — — A 3.0
— 280 — — A 5.0
D030 — 3.5 7 — A 1.8 Cap Sense, Low Power mode
—7 9 —A3.0
D030 — 17 38 — A 1.8 Cap Sense, Low Power mode
— 21 50 — A 3.0
— 22 70 — A 5.0
D031 — 1 — — A 3.6 LCD Bias Ladder, Low-power
—10 — — A3.6
LCD Bias Ladder, Medium-power
—100 — — A3.6
LCD Bias Ladder, High-power
D031 — 1 — — A 5.0 LCD Bias Ladder, Low-power
— 10 — — A 5.0
LCD Bias Ladder, Medium-power
— 100 — — A 5.0
LCD Bias Ladder, High-power
31.3 DC Characteristics: PIC16F/LF1938/39-I/E (Power-Down) (Continued)
PIC16LF1938/39
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  T
A  +125°C for extended
PIC16F1938/39
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial
-40°C  T
A  +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Legend: TBD = To Be Determined
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral  current can be determined by subtracting the base I
DD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: A/D oscillator source is F
RC.
4: 0.1 F capacitor on V
CAP (RA0).