Datasheet
2009 Microchip Technology Inc. Preliminary DS41364D-page 449
PIC16F193X/LF193X
Supply Current (IDD)
(1, 2)
D013 — 90
125
A1.8FOSC = 500 kHz
EC Oscillator Low-Power mode
— 170
200
A3.0
D013 — 100
180
A 1.8 FOSC = 500 kHz
EC Oscillator Low-Power mode (Note 5)
— 180
310
A 3.0
— 225
350
A 5.0
D014 — 450 650 A1.8F
OSC = 4 MHz
EC Oscillator mode
Medium Power mode
— 830
1100
A3.0
D014 — 475 735 A 1.8 FOSC = 4 MHz
EC Oscillator mode (Note 5)
Medium Power mode
— 850 1200 A 3.0
— 980 1390 A 5.0
D015 — 5.3
7.3
mA 3.0 F
OSC = 32 MHz
EC Oscillator High-Power mode
—6.0
8.0
mA 3.6
D015 — 5.3
7.3
mA 3.0 FOSC = 32 MHz
EC Oscillator High-Power mode (Note 5)
— 6.0
8.0
mA 5.0
D016 — 5
12
A1.8F
OSC = 32 kHz
LFINTOSC mode, 85°C
—8
16
A3.0
D016 — 21
35
A 1.8 FOSC = 32 kHz
LFINTOSC mode, 85°C (Note 5)
— 27
40
A 3.0
— 28
45
A 5.0
31.2 DC Characteristics: PIC16F/LF1938/39-I/E (Industrial, Extended) (Continued)
PIC16LF1938/39
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C T
A +125°C for extended
PIC16F1938/39
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Param
No.
Device
Characteristics
Min. Typ† Max. Units
Conditions
V
DD Note
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
3: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can be extended
by the formula I
R = VDD/2REXT (mA) with REXT in k
4: FVR and BOR are disabled.
5: 0.1 F capacitor on V
CAP (RA0).
6: 8 MHz crystal oscillator with 4x PLL enabled.