Datasheet
PIC16F193X/LF193X
DS41364D-page 386 Preliminary 2009 Microchip Technology Inc.
D017
Supply Current (I
DD)
(1, 2)
— 130 175 A1.8FOSC = 500 kHz
MFINTOSC mode
— 190 250 A3.0
D017 — 150 250 A 1.8 FOSC = 500 kHz
MFINTOSC mode (Note 5)
— 210 345 A 3.0
— 270 425 A 5.0
D018 — 800 1100 A1.8F
OSC = 8 MHz
HFINTOSC mode
— 1300 1700 A3.0
D018 — 0.85 1.2 mA 1.8 FOSC = 8 MHz
HFINTOSC mode (Note 5)
— 1.4 1.9 mA 3.0
— 1.6 2.2 mA 5.0
D019 — 1.25 1.75 mA 1.8 F
OSC = 16 MHz
HFINTOSC mode
—2.02.5mA 3.0
D019 — 1.4 2.0 mA 1.8 FOSC = 16 MHz
HFINTOSC mode (Note 5)
— 2.2 2.8 mA 3.0
— 2.4 3.0 mA 5.0
D020 — 300 450 A1.8F
OSC = 4 MHz
EXTRC mode (Note 3, Note 5)
— 500 700 A3.0
D020 — 350 600 A 1.8 FOSC = 4 MHz
EXTRC mode (Note 3, Note 5)
— 550 900 A 3.0
— 620 1000 A 5.0
D021 — 3.4 — mA 3.0 F
OSC = 32 MHz
HS Oscillator mode (Note 6)
—4.2 — mA 3.6
D021 — 3.6 — mA 3.0 FOSC = 32 MHz
HS Oscillator mode (Note 5, Note 6)
— 3.9 — mA 5.0
29.2 DC Characteristics: PIC16F/LF1933-I/E (Industrial, Extended) (Continued)
PIC16LF1933
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C T
A +125°C for extended
PIC16F1933
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Param
No.
Device
Characteristics
Min. Typ† Max. Units
Conditions
V
DD Note
Note 1: The test conditions for all I
DD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
3: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can be extended
by the formula I
R = VDD/2REXT (mA) with REXT in k
4: FVR and BOR are disabled.
5: 0.1 F capacitor on V
CAP (RA0).
6: 8 MHz crystal oscillator with 4x PLL enabled.