Datasheet
PIC16(L)F1934/6/7
DS41364E-page 388 2008-2011 Microchip Technology Inc.
Power-down Base Current (I
PD)
(2)
D028 — 0.1 4.0 8.0 A 1.8 A/D Current (Note 1, Note 3), no
conversion in progress
— 0.1 5.0 9.0 A3.0
D028 — 22 56 63 A 1.8 A/D Current (Note 1, Note 3), no
conversion in progress
— 26 58 78 A 3.0
— 27 61 88 A 5.0
D029 — 250 — — A 1.8 A/D Current (Note 1, Note 3),
conversion in progress
—250 — — A3.0
D029 — 280 — — A 1.8 A/D Current (Note 1, Note 3,
Note 4), conversion in progress
— 280 — — A 3.0
— 280 — — A 5.0
D030 — 2 7 11 A 1.8 Cap Sense, Low-Power mode
—3 9 13A3.0
D030 — 21 61 63 A 1.8 Cap Sense, Low-Power mode
— 27 63 78 A 3.0
— 28 66 88 A 5.0
D031 — 1 — — A 3.0 LCD Bias Ladder, Low-power
—10 — — A 3.0 LCD Bias Ladder, Medium-power
—75 — — A 3.0 LCD Bias Ladder, High-power
D031 — 1 — — A 5.0 LCD Bias Ladder, Low-power
— 10 — — A 5.0 LCD Bias Ladder, Medium-power
— 75 — — A 5.0 LCD Bias Ladder, High-power
D032 — 7.6 22 25 A 1.8 Comparator, Low-Power mode
— 8.0 23 27 A3.0
D032 — 24 65 75 A 1.8 Comparator, Low-Power mode
— 26 75 88 A 3.0
— 28 77 97 A 5.0
30.3 DC Characteristics: PIC16(L)F1934/6/7-I/E (Power-Down) (Continued)
PIC16LF1934/36/37
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C T
A +125°C for extended
PIC16F1934/36/37
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The peripheral current is the sum of the base I
DD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral current can be determined by subtracting the base I
DD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: A/D oscillator source is F
RC.
4: 0.1 F capacitor on V
CAP (RA0).