Datasheet
PIC16(L)F1847
DS40001453E-page 350 2011-2013 Microchip Technology Inc.
TABLE 30-2: SUPPLY CURRENT (IDD)
(1,2)
PIC16LF1847 Standard Operating Conditions (unless otherwise stated)
PIC16F1847
Param.
No.
Device
Characteristics
Min. Typ† Max. Units
Conditions
V
DD Note
D010 — 9.5
14
A1.8
F
OSC = 32 kHz
LP Oscillator
-40°C TA +85°C
—12.5
17
A3.0
D010 — 22
29
A 1.8
FOSC = 32 kHz
LP Oscillator
-40°C TA +85°C
— 27
35
A 3.0
— 30
38
A 5.0
D010A — 9.5
14
A1.8
F
OSC = 32 kHz
LP Oscillator
-40°C TA +125°C
—12.5
17
A3.0
D010A — 22
29
A 1.8
FOSC = 32 kHz
LP Oscillator
-40°C T
A +125°C
— 27
35
A 3.0
— 30
38
A 5.0
D011 — 105
110
A1.8F
OSC = 1 MHz
XT Oscillator
— 160
190
A3.0
D011 — 132
154
A 1.8 FOSC = 1 MHz
XT Oscillator
— 186
220
A 3.0
— 216
290
A 5.0
D012 — 264
370
A1.8F
OSC = 4 MHz
XT Oscillator
— 491
620
A3.0
D012 — 285
300
A 1.8 FOSC = 4 MHz
XT Oscillator
— 408
600
A 3.0
— 490
700
A 5.0
D013 — 55
160
A1.8F
OSC = 1 MHz
EC Oscillator
Medium-Power mode
—90
230
A3.0
D013 — 75
95
A 1.8 FOSC = 1 MHz
EC Oscillator
Medium-Power mode
— 116
130
A 3.0
— 145
185
A 5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave,
from rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O
pin loading and switching rate, oscillator type, internal code execution pattern and temperature, also have
an impact on the current consumption.
3: 8 MHz internal oscillator with 4x PLL enabled.
4: 8 MHz crystal oscillator with 4x PLL enabled.
5: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can
be extended by the formula I
R = VDD/2REXT (mA) with REXT in k