Datasheet
2011-2013 Microchip Technology Inc. DS40001453E-page 33
PIC16(L)F1847
Bank 6
300h
(1)
INDF0 Addressing this location uses contents of FSR0H/FSR0L to address data memory
(not a physical register)
xxxx xxxx xxxx xxxx
301h
(1)
INDF1 Addressing this location uses contents of FSR1H/FSR1L to address data memory
(not a physical register)
xxxx xxxx xxxx xxxx
302h
(1)
PCL Program Counter (PC) Least Significant Byte 0000 0000 0000 0000
303h
(1)
STATUS — — —TOPD ZDCC---1 1000 ---q quuu
304h
(1)
FSR0L Indirect Data Memory Address 0 Low Pointer 0000 0000 uuuu uuuu
305h
(1)
FSR0H Indirect Data Memory Address 0 High Pointer 0000 0000 0000 0000
306h
(1)
FSR1L Indirect Data Memory Address 1 Low Pointer 0000 0000 uuuu uuuu
307h
(1)
FSR1H Indirect Data Memory Address 1 High Pointer 0000 0000 0000 0000
308h
(1)
BSR — — — BSR<4:0> ---0 0000 ---0 0000
309h
(1)
WREG Working Register 0000 0000 uuuu uuuu
30Ah
(1)
PCLATH — Write Buffer for the upper 7 bits of the Program Counter -000 0000 -000 0000
30Bh
(1)
INTCON GIE PEIE TMR0IE INTE IOCE TMR0IF INTF IOCF 0000 000x 0000 000u
30Ch
— Unimplemented — —
30Dh
— Unimplemented — —
30Eh
— Unimplemented — —
30Fh
— Unimplemented — —
310h
— Unimplemented — —
311h CCPR3L Capture/Compare/PWM Register 3 (LSB) xxxx xxxx uuuu uuuu
312h CCPR3H Capture/Compare/PWM Register 3 (MSB) xxxx xxxx uuuu uuuu
313h CCP3CON
— — DC3B<1:0> CCP3M<3:0> --00 0000 --00 0000
314h
— Unimplemented — —
315h
— Unimplemented — —
316h
— Unimplemented — —
317h
— Unimplemented — —
318h CCPR4L Capture/Compare/PWM Register 4 (LSB) xxxx xxxx uuuu uuuu
319h CCPR4H Capture/Compare/PWM Register 4 (MSB) xxxx xxxx uuuu uuuu
31Ah CCP4CON
— — DC4B<1:0> CCP4M<3:0> --00 0000 --00 0000
31Bh
— Unimplemented — —
31Ch
— Unimplemented — —
31Dh
— Unimplemented — —
31Eh
— Unimplemented — —
31Fh
— Unimplemented — —
TABLE 3-8: SPECIAL FUNCTION REGISTER SUMMARY (CONTINUED)
Address Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Value on
POR, BOR
Value on
all other
Resets
Legend: x = unknown, u = unchanged, q = value depends on condition, - = unimplemented, r = reserved.
Shaded locations are unimplemented, read as ‘0’.
Note 1: These registers can be addressed from any bank.
2: Unimplemented, read as ‘1’.