Datasheet
PIC16(L)F1825/1829
DS41440C-page 352 2010-2012 Microchip Technology Inc.
30.2 DC Characteristics: PIC16(L)F1825/1829-I/E (Industrial, Extended)
PIC16LF1825/1829
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C T
A +125°C for extended
PIC16F1825/1829
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Param
No.
Device
Characteristics
Min. Typ† Max. Units
Conditions
V
DD Note
Supply Current (I
DD)
(1, 2)
D010 — 5.5
15
A1.8
F
OSC = 32 kHz
LP Oscillator mode
—7.8
18
A3.0
D010 — 20
55
A 1.8
FOSC = 32 kHz
LP Oscillator mode
— 25
60
A 3.0
— 27
65
A 5.0
D011 — 83
140
A1.8F
OSC = 1 MHz
XT Oscillator mode
— 130
230
A3.0
D011 — 105
160
A 1.8 FOSC = 1 MHz
XT Oscillator mode
— 160
250
A 3.0
— 230
320
A 5.0
D012 — 220
310
A1.8F
OSC = 4 MHz
XT Oscillator mode
— 378
540
A3.0
D012 — 240
300
A 1.8 FOSC = 4 MHz
XT Oscillator mode
— 400
500
A 3.0
— 500
760
A 5.0
D013 — 46
160
A1.8F
OSC = 1 MHz
EC Oscillator mode, Medium-Power mode
—90
230
A3.0
D013 — 70
180
A 1.8 FOSC = 1 MHz
EC Oscillator mode
Medium-Power mode
— 120
240
A 3.0
— 190
320
A 5.0
D014 — 192
250
A1.8F
OSC = 4 MHz
EC Oscillator mode,
Medium-Power mode
— 336
430
A3.0
D014 — 210
275
A 1.8 FOSC = 4 MHz
EC Oscillator mode
Medium-Power mode
— 356
450
A 3.0
— 430
650
A 5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
3: 8 MHz internal RC oscillator with 4xPLL enabled.
4: 8 MHz crystal oscillator with 4xPLL enabled.
5: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can be extended
by the formula I
R = VDD/2REXT (mA) with REXT in k.