Datasheet

PIC16(L)F1824/1828
DS41419D-page 372  2010-2012 Microchip Technology Inc.
TABLE 30-5: RESET, WATCHDOG TIMER, OSCILLATOR START-UP TIMER, POWER-UP TIMER
AND BROWN-OUT RESET PARAMETERS
FIGURE 30-10: TIMER0 AND TIMER1 EXTERNAL CLOCK TIMINGS
Standard Operating Conditions (unless otherwise stated)
Operating Temperature -40°C T
A +125°C
Param
No.
Sym. Characteristic Min. Typ† Max. Units Conditions
30 TMCLMCLR Pulse Width (low) 2 — — s
31 T
WDTLP Watchdog Timer
Time-out Period (No Prescaler)
12 16 20 ms VDD = 3.3V-5V
32 T
OST Oscillator Start-up Timer Period
(NOTE 1)
— 1024 — Tosc
33* T
PWRT Power-up Timer Period, PWRTE = 0 40 65 140 ms
34* TIOZ I/O high-impedance from MCLR Low
or Watchdog Timer Reset
——2.0s
35 V
BOR Brown-out Reset Voltage (NOTE 2) 2.55
1.80
2.70
1.9
2.85
2.05
V
V
BORV = 0
BORV = 1
36* V
HYST Brown-out Reset Hysteresis 20 35 60 mV -40°C to +85°C
37* TBORDC Brown-out Reset DC Response Time 0 1 35 sVDD  VBOR
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance
only and are not tested.
Note 1: By design, the Oscillator Start-up (OST) counts the first 1.024 cycles, independent of frequency.
2: To ensure these voltage tolerances, V
DD and VSS must be capacitively decoupled as close to the device as
possible. 0.1 F and 0.01 F values in parallel are recommended.
T0CKI
T1CKI
40
41
42
45
46
47
49
TMR0 or
TMR1