Datasheet
PIC16(L)F1824/1828
DS41419D-page 50 2010-2012 Microchip Technology Inc.
REGISTER 4-1: CONFIGURATION WORD 1
R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1
FCMEN IESO CLKOUTEN
BOREN<1:0> CPD
bit 13 bit 8
R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1 R/P-1/1
CP
MCLRE PWRTE WDTE<1:0> FOSC<2:0>
bit 7 bit 0
Legend:
R = Readable bit P = Programmable bit U = Unimplemented bit, read as ‘1’
‘0’ = Bit is cleared ‘1’ = Bit is set -n = Value when blank or after Bulk Erase
bit 13 FCMEN: Fail-Safe Clock Monitor Enable bit
1 = Fail-Safe Clock Monitor is enabled
0 = Fail-Safe Clock Monitor is disabled
bit 12 IESO: Internal External Switchover bit
1 = Internal/External Switchover mode is enabled
0 = Internal/External Switchover mode is disabled
bit 11 CLKOUTEN
: Clock Out Enable bit
If
FOSC Configuration bits are set to LP, XT, HS modes:
This bit is ignored, CLKOUT function is disabled. Oscillator function on the CLKOUT pin.
All other
FOSC modes:
1 = CLKOUT function is disabled. I/O function on the CLKOUT pin.
0 = CLKOUT function is enabled on the CLKOUT pin
bit 10-9 BOREN<1:0>: Brown-out Reset Enable bits
(1)
11 = BOR enabled
10 = BOR enabled during operation and disabled in Sleep
01 = BOR controlled by SBOREN bit of the BORCON register
00 = BOR disabled
bit 8 CPD
: Data Code Protection bit
(2)
1 = Data memory code protection is disabled
0 = Data memory code protection is enabled
bit 7 CP
: Code Protection bit
(3)
1 = Program memory code protection is disabled
0 = Program memory code protection is enabled
bit 6 MCLRE: RA3/MCLR
/VPP Pin Function Select bit
If LVP bit =
1:
This bit is ignored.
If LVP bit =
0:
1 =MCLR
/VPP pin function is MCLR; Weak pull-up enabled.
0 =MCLR
/VPP pin function is digital input; MCLR internally disabled; Weak pull-up under control of WPUA register.
bit 5 PWRTE
: Power-up Timer Enable bit
(1)
1 = PWRT disabled
0 = PWRT enabled
bit 4-3 WDTE<1:0>: Watchdog Timer Enable bit
11 = WDT enabled
10 = WDT enabled while running and disabled in Sleep
01 = WDT controlled by the SWDTEN bit in the WDTCON register
00 = WDT disabled
Note 1: Enabling Brown-out Reset does not automatically enable Power-up Timer.
2: The entire data EEPROM will be erased when the code protection is turned off during an erase.
3: The entire program memory will be erased when the code protection is turned off.