Datasheet

PIC12(L)F1822/PIC16(L)F1823
DS41413C-page 348  2010-2012 Microchip Technology Inc.
Supply Current (I
DD)
(1, 2)
D020 — 2.0
3.1
mA 3.0 FOSC = 32 MHz
HS Oscillator mode (Note 4)
—2.5
3.5
mA 3.6
D020 — 2.0
3.1
mA 3.0 FOSC = 32 MHz
HS Oscillator mode (Note 4)
— 2.5
3.5
mA 5.0
D021 — 210
425
A1.8F
OSC = 4 MHz
EXTRC mode (Note 5)
— 470
800
A3.0
D021 — 350
435
A 1.8 FOSC = 4 MHz
EXTRC mode (Note 5)
— 550
800
A 3.0
— 620
850
A 5.0
30.2 DC Characteristics: PIC12(L)F1822/PIC16(L)F1823-I/E (Industrial, Extended)
PIC12LF1822/16LF1823
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C  T
A  +125°C for extended
PIC12F1822/16F1823
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial
-40°C  T
A  +125°C for extended
Param
No.
Device
Characteristics
Min. Typ† Max. Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note 1: The test conditions for all IDD measurements in active operation mode are: OSC1 = external square wave, from
rail-to-rail; all I/O pins tri-stated, pulled to V
DD; MCLR = VDD; WDT disabled.
2: The supply current is mainly a function of the operating voltage and frequency. Other factors, such as I/O pin loading
and switching rate, oscillator type, internal code execution pattern and temperature, also have an impact on the current
consumption.
3: 8 MHz internal RC oscillator with 4x PLL enabled.
4: 8 MHz crystal oscillator with 4x PLL enabled.
5: For RC oscillator configurations, current through R
EXT is not included. The current through the resistor can be extended
by the formula I
R = VDD/2REXT (mA) with REXT in k