Datasheet
PIC16(L)F1782/3
DS41579D-page 376 Preliminary 2011-2012 Microchip Technology Inc.
Power-down Base Current (IPD)
(2, 5)
D029 — 0.05 2 9 A 1.8 ADC Current (Note 1, Note 3), no
conversion in progress
—0.08 3 10
A3.0
D029 — 0.3 4 12 A 2.3 ADC Current (Note 1, Note 3), no
conversion in progress
— 0.4 5 13 A 3.0
— 0.5 7 16 A 5.0
D030 — 250 — —
A 1.8 ADC Current (Note 1, Note 3),
conversion in progress
—280 — —
A3.0
D030 — 230 — — A 2.3 ADC Current (Note 1, Note 3,
Note 4)
, conversion in progress
— 250 — — A 3.0
— 350 — — A 5.0
D031 — 250 400 —
A 3.0 Op Amp (High power)
D031 — 230 380 — A 2.3 Op Amp (High power)
— 250 400 — A 3.0
— 350 500 — A 5.0
D032 — 250 — —
A 1.8 Comparator, High-Power mode
—300 — —
A3.0
D032 — 280 — — A 2.3 Comparator, High-Power mode
— 300 — — A 3.0
— 310 — — A 5.0
D033 — TBD — —
A 3.0 PSMC (64 MHz)
—TBD — —
A3.6
D033 — TBD — — A 3.0
— TBD — — A 5.0
30.3 DC Characteristics: PIC16(L)F1782/3-I/E (Power-Down) (Continued)
PIC16LF1782/3
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C
TA +125°C for extended
PIC16F1782/3
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C TA +85°C for industrial
-40°C
TA +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Legend: TBD = To Be Determined
Note 1: The peripheral current is the sum of the base IPD and the additional current consumed when this peripheral is enabled.
The peripheral
current can be determined by subtracting the base IDD or IPD current from this limit. Max values should
be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD, and VREGCON = 0x03.
3: ADC oscillator source is FRC.
4: 0.1 F capacitor on VCAP.
5: VREGPM = 1.