Datasheet

PIC16(L)F1516/7/8/9
DS41452C-page 106  2010-2012 Microchip Technology Inc.
TABLE 11-3: SUMMARY OF REGISTERS ASSOCIATED WITH FLASH PROGRAM MEMORY
TABLE 11-4: SUMMARY OF CONFIGURATION WORD WITH FLASH PROGRAM MEMORY
REGISTER 11-6: PMCON2: PROGRAM MEMORY CONTROL 2 REGISTER
W-0/0 W-0/0 W-0/0 W-0/0 W-0/0 W-0/0 W-0/0 W-0/0
Program Memory Control Register 2
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
S = Bit can only be set x = Bit is unknown -n/n = Value at POR and BOR/Value at all other Resets
‘1’ = Bit is set ‘0’ = Bit is cleared
bit 7-0 Flash Memory Unlock Pattern bits
To unlock writes, a 55h must be written first, followed by an AAh, before setting the WR bit of the
PMCON1 register. The value written to this register is used to unlock the writes. There are specific
timing requirements on these writes.
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Register on
Page
INTCON GIE PEIE TMR0IE INTE IOCIE TMR0IF INTF IOCIF
76
PMCON1
—
(1)
CFGS LWLO FREE WRERR WREN WR RD
105
PMCON2 Program Memory Control Register 2
106
PMADRL PMADRL<7:0>
104
PMADRH
—
(1)
PMADRH<6:0> 104
PMDATL PMDATL<7:0>
104
PMDATH
— — PMDATH<5:0> 104
Legend: — = unimplemented location, read as ‘0’. Shaded cells are not used by Flash program memory.
Note 1: Unimplemented, read as ‘1’.
Name Bits Bit -/7 Bit -/6 Bit 13/5 Bit 12/4 Bit 11/3 Bit 10/2 Bit 9/1 Bit 8/0
Register
on Page
CONFIG1
13:8
FCMEN IESO CLKOUTEN BOREN<1:0> —
42
7:0 CP MCLRE PWRTE WDTE<1:0> FOSC<2:0>
CONFIG2
13:8
LVP DEBUG — BORV STVREN —
44
7:0 — — — VCAPEN
(1)
— —WRT<1:0>
Legend: — = unimplemented location, read as ‘0’. Shaded cells are not used by Flash program memory.