Datasheet

ManualsBrandsMICROCHIP TECHNOLOGY ManualsMicrocontrollers, Microprocessors & QuartzesEmbedded microcontroller SPDIP 28 8-Bit 20 MHz I/O number 25

PIC16(L)F1512/3

DS41624B-page 40 Preliminary  2012 Microchip Technology Inc.

R/P-1 R/P-1 R/P-1 R/P-1 R/P-1 U-1

LVP DEBUG

LPBOR BORV STVREN —

bit 13 bit 8

U-1 U-1 U-1 R/P-1 U-1 U-1 R/P-1 R/P-1

— — — VCAPEN

(1)

— —WRT<1:0>

bit 7 bit 0

Legend:

R = Readable bit P = Programmable bit U = Unimplemented bit, read as ‘1’

‘0’ = Bit is cleared ‘1’ = Bit is set -n = Value when blank or after Bulk Erase

bit 13 LVP: Low-Voltage Programming Enable bit

1 = Low-voltage programming enabled

0 = High-voltage on MCLR

must be used for programming

bit 12 DEBUG: In-Circuit Debugger Mode bit

1 = In-Circuit Debugger disabled, ICSPCLK and ICSPDAT are general purpose I/O pins

0 = In-Circuit Debugger enabled, ICSPCLK and ICSPDAT are dedicated to the debugger

bit 11 LPBOR: Low-Power BOR bit

1 = Low-Power BOR is disabled

0 = Low-Power BOR is enabled

bit 10 BORV: Brown-out Reset Voltage Selection bit

1 = Brown-out Reset voltage set to 1.9V (typical) for PIC16LF1512/3 and 2.45V on PIC16F1512/3

0 = Brown-out Reset voltage set to 2.7V (typical)

bit 9 STVREN: Stack Overflow/Underflow Reset Enable bit

1 = Stack Overflow or Underflow will cause a Reset

0 = Stack Overflow or Underflow will not cause a Reset

bit 8-5 Unimplemented: Read as ‘1’

bit 4 VCAPEN

: Voltage Regulator Capacitor Enable bits

(1)

If PIC16LF1512/3 (regulator disabled):

These bits are ignored. All V

CAP pin functions are disabled.

PIC16F1512/3 (regulator enabled):

0 =V

CAP functionality is enabled on RA5

1 =All V

CAP pin functions are disabled

bit 3-2 Unimplemented: Read as ‘1’

bit 1-0 WRT<1:0>: Flash Memory Self-Write Protection bits

2 kW Flash memory (PIC16(L)F1512 only)

11 = Write protection off

10 = 000h to 1FFh write-protected, 200h to 7FFh may be modified by PMCON control

01 = 000h to 3FFh write-protected, 400h to 7FFh may be modified by PMCON control

00 = 000h to 7FFh write-protected, no addresses may be modified by PMCON control

4 kW Flash memory (PIC16(L)F1513 only)

11 = Write protection off

10 = 000h to 1FFh write-protected, 200h to FFFh may be modified by PMCON control

01 = 000h to 7FFh write-protected, 800h to FFFh may be modified by PMCON control

00 = 000h to FFFh write-protected, no addresses may be modified by PMCON control

Note 1: PIC16F1512/3 only.