Datasheet

2011 Microchip Technology Inc. Preliminary DS41607A-page 107
PIC16(L)F1503
TABLE 11-6: SUMMARY OF REGISTERS ASSOCIATED WITH PORTC
REGISTER 11-10: ANSELC: PORTC ANALOG SELECT REGISTER
U-0 U-0 U-0 U-0 R/W-1/1 R/W-1/1 R/W-1/1 R/W-1/1
ANSC3 ANSC2 ANSC1 ANSC0
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
u = Bit is unchanged x = Bit is unknown -n/n = Value at POR and BOR/Value at all other Resets
‘1’ = Bit is set ‘0’ = Bit is cleared
bit 7-4 Unimplemented: Read as ‘0
bit 3-0 ANSC<3:0>: Analog Select between Analog or Digital Function on pins RC<3:0>, respectively
1 = Analog input. Pin is assigned as analog input
(1)
. Digital input buffer disabled.
0 = Digital I/O. Pin is assigned to port or digital special function.
Note 1: When setting a pin to an analog input, the corresponding TRIS bit must be set to Input mode in order to
allow external control of the voltage on the pin.
REGISTER 11-11: WPUC: WEAK PULL-UP PORTC REGISTER
U-0 U-0 R/W-1/1 R/W-1/1 R/W-1/1 R/W-1/1 R/W-1/1 R/W-1/1
WPUC5 WPUC4 WPUC3 WPUC2 WPUC1 WPUC0
bit 7 bit 0
Legend:
R = Readable bit W = Writable bit U = Unimplemented bit, read as ‘0’
u = Bit is unchanged x = Bit is unknown -n/n = Value at POR and BOR/Value at all other Resets
‘1’ = Bit is set ‘0’ = Bit is cleared
bit 7-6 Unimplemented: Read as ‘0
bit 5-0 WPUC<5:0>: Weak Pull-Up Register bits
(1, 2)
1 = Pull-up enabled
0 = Pull-up disabled
Note 1: Global WPUEN
bit of the OPTION_REG register must be cleared for individual pull-ups to be enabled.
2: The weak pull-up device is automatically disabled if the pin is in configured as an output.
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Register
on Page
ANSELC ANSC3 ANSC2 ANSC1 ANSC0 107
LATC
LATC5 LATC4 LATC3 LATC2 LATC1 LATC0 106
PORTC
RC5 RC4 RC3 RC2 RC1 RC0 106
TRISC
TRISC5 TRISC4 TRISC3 TRISC2 TRISC1 TRISC0 106
WPUC
WPUC5 WPUC4 WPUC3 WPUC2 WPUC1 WPUC0 107
Legend: x = unknown, u = unchanged, - = unimplemented locations read as ‘0’. Shaded cells are not used by PORTC.