Datasheet

PIC16(L)F1454/5/9
DS41639A-page 360 Preliminary  2012 Microchip Technology Inc.
29.3 DC Characteristics: PIC16(L)F1454/5/9-I/E (Power-Down)
PIC16LF1454/5/9
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C
 TA  +125°C for extended
PIC16F1454/5/9
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  TA  +85°C for industrial
-40°C
 TA  +125°C for extended
Param
No.
Device Characteristics Min. Typ†
Max.
+85°C
Max.
+125°C
Units
Conditions
V
DD Note
Power-down Current (I
PD)
(2)
D022 — 0.025 — — A 1.8 Base Current: WDT, BOR, FVR,
and SOSC disabled, all Peripher-
als inactive
— 0.035 — —
A3.0
D022 — 0.20 — — A 2.3 WDT, BOR, FVR, and SOSC dis-
abled, all Peripherals inactive
(VREGPM = 1; Low-Power mode)
— 0.25 — — A 3.0
— 0.30 — — A 5.0
D022A — 10 — — A 2.3 Base Current: WDT, BOR, FVR
and SOSC disabled, all peripheral
inactive (VREGPM = 0; Normal
Power mode)
— 11 — — A 3.0
— 12 — — A 5.0
D023 — 0.29 — —
A 1.8 LPWDT Current (Note 1)
—0.39 — — A3.0
D023 — 10.5 — — A 2.3 LPWDT Current (Note 1)
— 11.3 — — A 3.0
— 12.5 — — A 5.0
D023A — 14 — —
A 1.8 FVR current (Note 1)
—23 — — A3.0
D023A — 23 — — A 2.3 FVR current (Note 1)
— 30 — — A 3.0
— 34 — — A 5.0
D024 — 7 — —
A 3.0 BOR Current (Note 1)
D024 — 15 — — A 3.0 BOR Current (Note 1)
— 17 — — A 5.0
D24A — 0.1 — — A 3.0 LPBOR Current (Note 1)
D24A — 11 — — A 3.0 LPBOR Current (Note 1)
— 12 — — A 5.0
* These parameters are characterized but not tested.
† Data in “Typ” column is at 3.0V, 25°C unless otherwise stated. These parameters are for design guidance only and are
not tested.
Note 1: The peripheral current is the sum of the base IDD or IPD and the additional current consumed when this peripheral is
enabled. The peripheral
 current can be determined by subtracting the base IDD or IPD current from this limit. Max
values should be used when calculating total current consumption.
2: The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD.
3: A/D oscillator source is FRC.