Datasheet

PIC16C77X
 1999-2013 Microchip Technology Inc. Advance Information DS30275B-page 155
Output High Voltage
D090 I/O ports (Note 3) V
OH VDD - 0.7
——
VIOH = -3.0 mA, VDD = 4.5V,
-40C to +85C
D092 OSC2/CLKOUT (RC osc config) V
DD - 0.7
——
VIOH = -1.3 mA, VDD = 4.5V,
-40C to +85C
D150* Open-Drain High Voltage V
OD
——
8.5 V RA4 pin
Capacitive Loading Specs on
Output Pins
D100 OSC2 pin C
OSC2
——
15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101
D102
All I/O pins and OSC2 (in RC
mode) SCL, SDA in I
2
C mode
C
IO
CB
—
—
—
—
50
400
pF
pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40°C  T
A  +85°C for industrial and
0°C  T
A  +70°C for commercial
Operating voltage V
DD range as described in DC spec Section 15.1 and
Section 15.2.
Param
No.
Characteristic Sym Min Typ† Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16C77X be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.
774.book Page 155 Tuesday, January 29, 2013 12:02 PM