Datasheet

PIC16C7X
DS30390E-page 224  1997 Microchip Technology Inc.
Applicable Devices 72 73 73A 74 74A 76 77
Output High Voltage
D090 I/O ports (Note 3) V
OH VDD - 0.7 - - V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D090A V
DD - 0.7 - - V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092 OSC2/CLKOUT (RC osc config) V
DD - 0.7 - - V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D092A V
DD - 0.7 - - V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D150* Open-Drain High Voltage V
OD - - 14 V RA4 pin
Capacitive Loading Specs on
Output Pins
D100 OSC2 pin C
OSC2 - - 15 pF In XT, HS and LP modes when exter-
nal clock is used to drive OSC1.
D101
D102
All I/O pins and OSC2 (in RC
mode) SCL, SDA in I
2
C mode
C
IO
CB
-
-
-
-
50
400
pF
pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40˚C ≤ T
A ≤ +125˚C for extended,
-40˚C ≤ T
A ≤ +85˚C for industrial and
0˚C ≤ T
A ≤ +70˚C for commercial
Operating voltage V
DD range as described in DC spec Section 20.1 and
Section 20.2.
Param
No.
Characteristic Sym Min Typ
†
Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
PIC16C7X be driven with external clock in RC mode.
2: The leakage current on the MCLR
pin is strongly dependent on the applied voltage level. The specified levels
represent normal operating conditions. Higher leakage current may be measured at different input voltages.
3: Negative current is defined as current sourced by the pin.