Datasheet

 1997 Microchip Technology Inc. DS30390E-page 171
PIC16C7X
Applicable Devices 72 73 73A 74 74A 76 77
Output High Voltage
D090 I/O ports (Note 3) V
OH VDD - 0.7 - - V IOH = -3.0 mA, VDD = 4.5V,
-40°C to +85°C
D090A V
DD - 0.7 - - V IOH = -2.5 mA, VDD = 4.5V,
-40°C to +125°C
D092 OSC2/CLKOUT (RC osc config) V
DD - 0.7 - - V IOH = -1.3 mA, VDD = 4.5V,
-40°C to +85°C
D092A V
DD - 0.7 - - V IOH = -1.0 mA, VDD = 4.5V,
-40°C to +125°C
D150* Open-Drain High Voltage V
OD - - 14 V RA4 pin
Capacitive Loading Specs on Out-
put Pins
D100 OSC2 pin C
OSC2 - - 15 pF In XT, HS and LP modes
when external clock is used to
drive OSC1.
D101
D102
All I/O pins and OSC2 (in RC mode)
SCL, SDA in I
2
C mode
C
IO
CB
-
-
-
-
50
400
pF
pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature -40˚C ≤ T
A ≤ +125˚C for extended,
-40˚C ≤ T
A ≤ +85˚C for industrial and
0˚C ≤ T
A ≤ +70˚C for commercial
Operating voltage V
DD range as described in DC spec Section 17.1
and Section 17.2.
Param
No.
Characteristic Sym Min Typ
†
Max Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator configuration, the OSC1/CLKIN pin is a Schmitt trigger input. It is not recommended that the
PIC16C7X be driven with external clock in RC mode.
2: The leakage current on the MCLR
/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input volt-
ages.
3: Negative current is defined as current sourced by the pin.