Datasheet

PIC16C62B/72A
DS35008C-page 90 Preliminary  1998-2013 Microchip Technology Inc.
13.4.3 TIMING DIAGRAMS AND SPECIFICATIONS
FIGURE 13-5: EXTERNAL CLOCK TIMING
TABLE 13-2: EXTERNAL CLOCK TIMING REQUIREMENTS
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
1A Fosc External CLKIN Frequency
(Note 1)
DC — 4 MHz RC and XT osc modes
DC — 4 MHz HS osc mode (-04)
DC — 20 MHz HS osc mode (-20)
DC — 200 kHz LP osc mode
Oscillator Frequency
(Note 1)
DC — 4 MHz RC osc mode
0.1 — 4 MHz XT osc mode
4 — 20 MHz HS osc mode
5 — 200 kHz LP osc mode
1
Tosc External CLKIN Period
(Note 1)
250 — — ns RC and XT osc modes
250 — — ns HS osc mode (-04)
50 — — ns HS osc mode (-20)
5— —sLP osc mode
Oscillator Period
(Note 1)
250 — — ns RC osc mode
250 — 10,000 ns XT osc mode
250 — 250 ns HS osc mode (-04)
50 — 250 ns HS osc mode (-20)
5— —sLP osc mode
2
TCY Instruction Cycle Time (Note 1) 200 — DC ns TCY = 4/FOSC
3*
To sL ,
To sH
External Clock in (OSC1) High
or Low Time
100 — — ns XT oscillator
2.5 — — s LP oscillator
15 — — ns HS oscillator
4*
To sR ,
To sF
External Clock in (OSC1) Rise
or Fall Time
— — 25 ns XT oscillator
— — 50 ns LP oscillator
— — 15 ns HS oscillator
* These parameters are characterized but not tested.
† Data in "Typ" column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: Instruction cycle period (T
CY) equals four times the input oscillator time-base period. All specified values are
based on characterization data for that particular oscillator type under standard operating conditions with the
device executing code. Exceeding these specified limits may result in an unstable oscillator operation and/or
higher than expected current consumption. All devices are tested to operate at "min." values with an external
clock applied to the OSC1/CLKIN pin.
When an external clock input is used, the "Max." cycle time limit is "DC" (no clock) for all devices.
3
3
4
4
1
2
Q4
Q1 Q2 Q3 Q4
Q1
OSC1
CLKOUT