Datasheet
PIC16C62B/72A
DS35008C-page 86 Preliminary 1998-2013 Microchip Technology Inc.
13.3 DC Characteristics: PIC16C62B/72A-04 (Commercial, Industrial, Extended)
PIC16C62B/72A-20 (Commercial, Industrial, Extended)
PIC16LC62B/72A-04 (Commercial, Industrial)
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0°C T
A +70°C for commercial
-40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Operating voltage V
DD range as described in DC spec Section 13.1
and Section 13.2
Param
No.
Sym Characteristic Min Typ† Max Units Conditions
Input Low Voltage
V
IL I/O ports
D030
D030A
with TTL buffer VSS
Vss
-
-
0.15V
DD
0.8V
V
V
For entire V
DD range
4.5V V
DD 5.5V
D031 with Schmitt Trigger buffer V
SS -0.2VDD V
D032 MCLR
, OSC1 (in RC mode) Vss - 0.2VDD V
D033 OSC1 (in XT, HS and LP
modes)
Vss - 0.3VDD V Note1
Input High Voltage
V
IH I/O ports -
D040 with TTL buffer 2.0 - V
DD V4.5V VDD 5.5V
D040A 0.25VD
D
+ 0.8V
- Vdd V For entire V
DD range
D041 with Schmitt Trigger buffer 0.8VDD -VDD V For entire VDD range
D042 MCLR 0.8VDD -VDD V
D042A OSC1 (XT, HS and LP modes) 0.7V
DD -VDD V Note1
D043 OSC1 (in RC mode) 0.9VDD -VddV
Input Leakage Current
(Notes 2, 3)
D060 I
IL I/O ports - - 1 AVss VPIN VDD,
Pin at hi-impedance
D061 MCLR
, RA4/T0CKI - - 5 AVss VPIN VDD
D063 OSC1 - - 5 AVss VPIN VDD,
XT, HS and LP osc modes
D070 I
PURB PORTB weak pull-up current 50 250 400 AVDD = 5V, VPIN = VSS
Output Low Voltage
D080 V
OL I/O ports - - 0.6 V IOL = 8.5 mA, VDD = 4.5V,
-40C to +85C
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC oscillator mode, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the
device be driven with external clock in RC mode.
2: The leakage current on the MCLR
/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input volt-
ages.
3: Negative current is defined as current sourced by the pin.