Datasheet

PIC16C712/716
DS41106C-page 84  1999-2013 Microchip Technology Inc.
FIGURE 12-8: TIMER0 AND TIMER1 EXTERNAL CLOCK TIMINGS
TABLE 12-5: TIMER0 AND TIMER1 EXTERNAL CLOCK REQUIREMENTS
Param
No.
Sym. Characteristic Min. Typ† Max. Units Conditions
40* Tt0H T0CKI High Pulse Width No Prescaler 0.5T
CY + 20 — — ns Must also meet
parameter 42
With Prescaler 10 — — ns
41* Tt0L T0CKI Low Pulse Width No Prescaler 0.5T
CY + 20 — — ns Must also meet
parameter 42
With Prescaler 10 — — ns
42* Tt0P T0CKI Period
No Prescaler
TCY + 40 — — ns
With Prescaler
Greater of:
20 or T
CY + 40
N
— — ns N = prescale value
(2, 4,..., 256)
45* Tt1H T1CKI High Time Synchronous, Prescaler = 1 0.5T
CY + 20 — — ns Must also meet
parameter 47
Synchronous,
Prescaler =
2,4,8
Standard
15 — — ns
Extended (LC)
25 — — ns
Asynchronous
Standard
30 — — ns
Extended (LC)
50 — — ns
46* Tt1L T1CKI Low Time Synchronous, Prescaler = 1 0.5T
CY + 20 — — ns Must also meet
parameter 47
Synchronous,
Prescaler =
2,4,8
Standard
15 — — ns
Extended (LC)
25 — — ns
Asynchronous
Standard
30 — — ns
Extended (LC)
50 — — ns
47* Tt1P T1CKI input period Synchronous
Standard
Greater of:
30 OR TCY + 40
N
— — ns N = prescale value
(1, 2, 4, 8)
Extended (LC)
Greater of:
50 OR TCY + 40
N
N = prescale value
(1, 2, 4, 8)
Asynchronous
Standard
60 — — ns
Extended (LC)
100 — — ns
Ft1 Timer1 oscillator input frequency range
(oscillator enabled by setting bit T1OSCEN)
DC — 200 kHz
48 TCKEZtmr1 Delay from external clock edge to timer increment 2Tosc — 7Tosc —
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25°C unless otherwise stated. These parameters are for design guidance only and are not
tested.
Note: Refer to Figure 12-3 for load conditions.
46
47
45
48
41
42
40
T0CKI
T1OSO/T1CKI
TMR0 or
TMR1