Datasheet
PIC16C712/716
DS41106C-page 78 1999-2013 Microchip Technology Inc.
Output Low Voltage
D080 V
OL I/O ports ——0.6 V IOL = 8.5 mA, VDD = 4.5V,
-40C to +85C
——0.6 V IOL = 7.0 mA, VDD = 4.5V,
-40C to +125C
D083 OSC2/CLKOUT
(RC Osc mode)
——0.6 V IOL = 1.6 mA, VDD = 4.5V,
-40C to +85C
——0.6 V IOL = 1.2 mA, VDD = 4.5V,
-40C to +125C
Output High Voltage
D090 V
OH I/O ports (Note 3) VDD-0.7 ——V IOH = -3.0 mA, VDD = 4.5V,
-40C to +85C
VDD-0.7 ——V IOH = -2.5 mA, VDD = 4.5V,
-40C to +125C
D092 OSC2/CLKOUT (RC Osc
mode)
VDD-0.7 ——V IOH = -1.3 mA, VDD = 4.5V,
-40C to +85C
V
DD-0.7 ——V IOH = -1.0 mA, VDD = 4.5V,
-40C to +125C
D150* VOD Open-Drain High Voltage ——8.5 V RA4 pin
Capacitive Loading Specs on
Output Pins
D100 C
OSC2 OSC2 pin ——15 pF In XT, HS and LP modes when
external clock is used to drive
OSC1.
D101 C
IO All I/O pins and OSC2 (in RC
mode)
——50 pF
DC CHARACTERISTICS
Standard Operating Conditions (unless otherwise stated)
Operating temperature 0°C T
A +70°C for commercial
-40°C T
A +85°C for industrial
-40°C T
A +125°C for extended
Operating voltage V
DD range as described in DC spec Section 12.1
“DC Characteristics: PIC16C712/716-04 (Commercial, Industrial,
Extended) PIC16C712/716-20 (Commercial, Industrial,
Extended)” and Section 12.2 “DC Characteristics: PIC16LC712/
716-04 (Commercial, Industrial)”
Param
No.
Sym. Characteristic Min. Typ† Max. Units Conditions
* These parameters are characterized but not tested.
† Data in “Typ” column is at 5V, 25C unless otherwise stated. These parameters are for design guidance only
and are not tested.
Note 1: In RC Oscillator mode, the OSC1/CLKIN pin is a Schmitt Trigger input. It is not recommended that the PIC
MCU be driven with external clock in RC mode.
2: The leakage current on the MCLR
/VPP pin is strongly dependent on the applied voltage level. The specified
levels represent normal operating conditions. Higher leakage current may be measured at different input
voltages.
3: Negative current is defined as current sourced by the pin.